Scribd
Upload
12 views1 page

Drafting Manual 7

Drafting Manual 7

Uploaded by

Wong Wesleykit
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
12 views1 page

Drafting Manual 7

Drafting Manual 7

Uploaded by

Wong Wesleykit
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

SEB Drafting Manual for RC Structures 2017 Page 2.

3 File Name: Drafting manual_Section 2 Date: September 2017

2.2.3 PRESENTATION OF STRUCTURAL ELEMENTS ON FRAMING PLANS

A) SLAB B) BEAM

1B2 (800~600~800x400)

(150)
ONE-WAY

1S5
SLAB

1B59 (600x400)
TWO-WAY 1S6
SLAB (150) 1B11 (800│600x400)

(600x400)
C1B58
C1S7
(150)
CANTILEVER
NAMING OF BEAM MARK
SLAB
1B2 FLOOR WHICH THE BEAM IS LOCATED

1B2 “B” DENOTES BEAM


NAMING OF SLAB MARK
1B2 BEAM NUMBER

DIRECTION OF SPAN C1B58 PREFIX “C” DENOTES CANTILEVER BEAM

(150) SLAB THICKNESS (600X400) SIZE OF RECTANGULAR BEAM (DEPTH X BREADTH)

1S6 FLOOR WHICH THE SLAB IS LOCATED (800~600~800X400)


SIZE OF TAPERED BEAM (START DEPTH ~
1S6 “S” DENOTES SLAB INTERMEDIATE DEPTH ~ END DEPTH X BREADTH)
1S6 SLAB NUMBER (800│600X400)
SIZE OF HAUNCHED BEAM (START DEPTH │END
C1S7 PREFIX “C” DENOTES CANTILEVER SLAB
DEPTH X BREADTH)
GENERAL REMARK FOR BEAMS
GENERAL REMARK FOR SLABS 1. EACH BEAM SHALL CARRY A UNIQUE MARK WITH SIZE SHOWN ON THE PLANS. A
SYSTEMATIC AND LOGICAL BEAM NAMING ARRANGEMENT SHALL BE ADOPTED. AN
1. EACH SLAB SHALL CARRY A UNIQUE MARK WITH THE THICKNESS AND EXAMPLE IS SHOWN IN THE FIGURE ABOVE.
DIRECTION OF SPAN SHOWN ON PLANS. A SYSTEMATIC AND LOGICAL SLAB
NAMING ARRANGEMENT SHALL BE ADOPTED. AN EXAMPLE IS SHOWN IN THE 2. BEAM MARK SHALL BE PLACED ON TOP OF A BEAM IF THE BEAM IS SPANNING IN
FIGURE ABOVE. HORIZONAL DIRECTION ON PLAN. SIMILARLY, BEAM MARK SHALL BE PLACED TO
THE LEFT OF A BEAM IF THE BEAM IS SPANNING IN VERTICAL DIRECTION ON PLAN.
2. WHERE MAJORITY OF THE FLOOR SLABS ARE OF A TYPICAL THICKNESS, THE
TYPICAL SLAB THICKNESS CAN BE INDICATED IN THE NOTES OF THE FLOOR 3. WHERE MAJORITY OF THE FLOOR BEAMS ARE OF A TYPICAL SIZE, THE TYPICAL
PLAN AND NEED NOT BE SHOWN FOR EACH SLAB MARK. BEAM SIZE CAN BE INDICATED IN THE NOTES OF THE FLOOR PLAN AND NEED NOT
BE SHOWN FOR EACH BEAM MARK.

ArchSD

You might also like