Scribd
Upload
25 views2 pages

Gac 250

Uploaded by

mohamad mostafavi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
25 views2 pages

Gac 250

Uploaded by

mohamad mostafavi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

GAC 250

PC/ABS Alloy : Non Reinforced Grade


Classification: General purpose>Injection grade
Characteristic: Injection grade, high impact Resistance
Application GAC 2۵٠ resin gives exceptional impact strength even at low temperature and has a high
heat resistance. Typical applications include automotive instrument panel, automotive interior and exterior
trim. Electrical and Electronic component and etc.

Test method Typical GBEAC 250


Property Test condition Unit
(ASTM) value Specification
Izod impact D-256 6.4 mm , notched Kj/m² 45 Min40
Melt flow index D-1238 230ºc , 21.6 kg gr/10 min 47 45-55
Rock well hardness D-785 ........ R-scale 113 100-120
HDT D-648 1.82 m pa ºc 125 Min115
Tensile strength D-638 23ºc , 50 mm/min Kg/cm² 550 Min520
Tensile elongation D-638 23ºc , 50 mm/min % 100 Min80
Flexural strength D-790 23ºc , 2.8 mm/min Kg/cm² 835 Min780
Flexural Modulus D-790 23ºc , 2.8 mm/min Kg/cm² 22500 Min19000
Specific Gravity D-792 23ºc .. 1.08 1.08
Molding Shrinkage D-955 … % 0.5-0.7 0.5-0.7
Flammability Ul94 1/8inch(3.2mm) … HB HB

TYPICAL PC/ABS PROCESSING CONDITIONS


The following molding conditions are recommended starting point for GBPC PC/ABS alloy. A moisture level of

Some modifications may be required depending on the specific molding equipment and part configuration.
DRYING: it is recommended that GBPC PC/ ABS Resins be dried at (80-95°c)for 3 hours.
INJECTION MOLDIN
Rear Temp(°c) Center Temp (°c) Center Temp (°c) Front Temp (°c) Nozzle Temp (°c) Melt Temp (°c)
230-240 230-240 240-250 250-260 260-270 260

Mold Temp (°c) Filling Speed


70-80 Slow-Med

You might also like