RGP02-12E // 20E HIGH VOLTAGE

FAST RECOVERY RECTIFIERS

PRV : 1200 - 2000 Volts
DO - 41
Io : 0.5 Ampere
FEATURES :
* Glass passivated junction
* High current capability 1.00 (25.4)
* High surge current capability 0.107 (2.7)
MIN.
0.080 (2.0)
* High reliability
* Low reverse current
* Low forward voltage drop 0.205 (5.2)
0.166 (4.2)
* Fast switching for high efficiency

MECHANICAL DATA : 1.00 (25.4)

0.034 (0.86)
* Case : DO-41 Molded plastic MIN.
0.028 (0.71)
* Epoxy : UL94V-O rate flame retardant
* Lead : Axial lead solderable per MIL-STD-202,
Method 208 guaranteed
* Polarity : Color band denotes cathode end
* Mounting position : Any Dimensions in inches and ( millimeters )
* Weight : 0.339 gram
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating at 25 °C ambient temperature unless otherwise specified.
Single phase, half wave, 60 Hz, resistive or inductive load.
For capacitive load, derate current by 20%.

RGP RGP RGP RGP RGP

RATING SYMBOL UNITS
02-12E 02-14E 02-16E 02-18E 02-20E
Maximum Recurrent Peak Reverse Voltage VRRM 1200 1400 1600 1800 2000 Volts
Maximum RMS Voltage VRMS 840 980 1120 1260 1400 Volts
Maximum DC Blocking Voltage VDC 1200 1400 1600 1800 2000 Volts
Maximum Average Forward Current
0.375"(9.5mm) Lead Length Ta = 55 °C IF(AV) 0.5 Amps.
Peak Forward Surge Current 8.3 ms. Single half sine wave
Superimposed on rated load (JEDEC Method) IFSM 20 Amps.
Maximum Peak Forward Voltage at 0.5 Amp. VF 2.5 Volts
Maximum DC Reverse Current Ta = 25 °C IR 5.0 µA
at Rated DC Blocking Voltage Ta = 100 °C IR(H) 50 µA
Maximum Reverse Recovery Time ( Note 1 ) Trr 300 ns
Typical Junction Capacitance ( Note 2 ) CJ 5.0 pf
Junction Temperature Range TJ - 65 to + 150 °C
Storage Temperature Range TSTG - 65 to + 150 °C

Notes :
( 1 ) Reverse Recovery Test Conditions : IF = 0.5 A, IR = 1.0 A, Irr = 0.25 A.
( 2 ) Measured at 1.0 MHz and applied reverse voltage of 4.0 V DC UPDATE : APRIL 23, 1998
 RATING AND CHARACTERISTIC CURVES ( RGP02-12E - RGP02-20E )

FIG.1 - REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM

Trr
50 Ω 10 Ω

+ 0.5 A

D.U.T. 0
+ PULSE
- 0.25
50 Vdc GENERATOR
(approx) ( NOTE 2 )

1Ω OSCILLOSCOPE - 1.0 A
( NOTE 1 )
SET TIME BASE FOR 50/100 ns/cm
NOTES : 1. Rise Time = 7 ns max., Input Impedance = 1 megaohm, 22 pF. 1 cm
2. Rise time = 10 ns max., Source Impedance = 50 ohms.
3. All Resistors = Non-inductive Types.

FIG.2 - DERATING CURVE FOR OUTPUT FIG.3 - MAXIMUM NON-REPETITIVE PEAK

RECTIFIED CURRENT FORWARD SURGE CURRENT
0.5 25
AVERAGE FORWARD OUTPUT

8.3 ms SINGLE HALF SINE WAVE

PEAK FORWARD SURGE

0.4 20 Ta = 50 °C
CURRENT, AMPERES
CURRENT, AMPERES

0.3 15

0.2 10

0.1 5

60Hz RESISTIVE OR INDUCTIVE LOAD

0 0
0 25 50 75 100 125 150 175 1 2 4 6 10 20 40 60 100

AMBIENT TEMPERATURE, ( °C) NUMBER OF CYCLES AT 60Hz

FIG.4 - TYPICAL FORWARD CHARACTERISTICS FIG.5 - TYPICAL REVERSE CHARACTERISTICS

2.0
REVERSE CURRENT, MICROAMPERES
FORWARD CURRENT, AMPERES

1.0 10

Pulse Width = 300 µs TJ = 100 °C

2% Duty Cycle

TJ = 25 °C
0.1 1.0

0.01 0.1
TJ = 25 °C

0.001 0.01
0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0 2.2 2.4 2.6 0 20 40 60 80 100 120 140
FORWARD VOLTAGE, VOLTS PERCENT OF RATED REVERSE
VOLTAGE, (%)
This datasheet has been download from:

www.datasheetcatalog.com

Datasheets for electronics components.