NS-C150/105 Natural Sound

Center Speaker System

Thank you for selecting this Yamaha NS-C150/105 speaker system.

This model is designed to be used as a center speaker system.

PRECAUTIONS PLACING THE SPEAKER

Read these precautions carefully before using your Place the speaker on top of the TV or on the floor Notes
speaker. under the TV or inside the TV rack so that it is stabi- • Do not place the speaker on top of the TV
● Any time you note distortion, reduce the volume lized. whose area is smaller than the bottom area of
control on your amplifier to a lower setting. Never the speaker. If placed, the speaker may drop out
allow your amplifier to be driven into “clipping”. When placing the speaker on top of the TV, to pre- causing an injury to you.
Otherwise the speaker may be damaged. vent the speaker from falling down, put the provided • Though this speaker is a magnetic shielding
● When using an amplifier with a rated output power velcro strips at two points on both bottom of the type, there may be some influence on a TV pic-
higher than the nominal input power of the speaker, speaker and top of the TV. ture depending on the type of TV or the place-
care should be taken never to exceed the speaker’s ment of the speaker. In such a case, place the
maximum input. speaker apart from the TV so that there is no
● Do not attempt to clean the speaker with chemical influence on TV picture.
solvents as this might damage the finish. To clean,
wipe with a dry, soft cloth.
● To prevent the enclosure from warping or discolor-
ing, do not place the speaker where it will be
exposed to direct sunlight or excessive humidity.
● Do not place the speaker where it is liable to be
knocked over or struck by falling objects. Stable Screen
placement will also ensure better sound perfor-
mance. Velcro
● Placing the speaker on the same shelf or rack as strip
the turntable can result in feedback.
● Secure placement or installation is the owner’s
responsibility.
YAMAHA shall not be liable for any accident
caused by improper placement or installation of
the speaker. TV set

1 2

Downloaded from: http://www.usersmanualguide.com/

 CONNECTION TO SPECIFICATIONS
YOUR AMPLIFIER
Type .......2 way acoustic-suspension speaker system
Magnetic-shielding type (EIAJ)
BEFORE MAKING CONNECTIONS, MAKE SURE <NS-C150>
THAT THE AMPLIFIER IS SWITCHED OFF. Speaker Unit ............12 cm cone woofer (JA1282) x 2
2.5 cm dome tweeter (JA05S5)
■ CONNECTIONS Input Terminal............................................Screw-type
Loosen
● Connect the screw-type input terminals at the rear Nominal Impedance.........................................6 ohms
Tighten Frequency Response ...........60 Hz – 20 kHz (–10 dB)
of the speaker to the speaker output terminals of
your amplifier with the provided speaker cables. Black(–) Resonance Frequency .....................................110 Hz
Nominal Input Power............................................60W
● One side of the speaker cable is red and the other
Music Input Power..............................................220W
side is black. Connect the (+) terminals on both the Sensitivity ...................................................90 dB/w/m
amplifier and the speakers using this red side. Red (+)
Crossover Frequency
Connect the (–) terminals on both components Tweeter (Low Cut).........................4 kHz, 12 dB/oct.
using the black side of the cable. If connected with Red Dimensions (WxHxD)..................600 x 150 x 200 mm
reversed polarity, the sound will be unnatural and (23-5/8” x 5-7/8” x 7-7/8”)
lack bass. Weight.......................................5.8 kg (12 lbs. 13 oz.)
Accessories ............................Speaker cable (4m) x 1
Procedures: Velcro strip x 2
➀ Loosen the terminal knob. Note
➁ Insert the bare wire end properly into the terminal Do not let the bare speaker wires touch each other <NS-C105>
as this could damage the speaker and/or Speaker Unit ............10 cm cone woofer (JA1076) x 2
hole. [Remove approx. 10 mm (3/8”) insulation 2.5 cm dome tweeter (JA05S5)
from the speaker cable.] the amplifier.
Input Terminal............................................Screw-type
➂ Tighten the knob. Nominal Impedance.........................................6 ohms
➃ Test the security of the connection by tugging * Banana Plug connections are also possible. First
Frequency Response ...........65 Hz – 20 kHz (–10 dB)
lightly on the cable at the terminal. tighten the terminal knob, and then insert the Resonance Frequency .....................................150 Hz
Banana Plug connector into the corresponding ter- Nominal Input Power............................................50W
minal hole. Music Input Power..............................................200W
Sensitivity ...................................................90 dB/w/m
Crossover Frequency
Tweeter (Low Cut)...........................6 kHz, 6 dB/oct.
Dimensions (WxHxD)..................540 x 135 x 180 mm
(21-1/4” x 5-5/16” x 7”)
Weight.....................................................5 kg (11 lbs.)
Accessories ............................Speaker cable (4m) x 1
Velcro strip x 2

* Specifications subject to change without notice due

to product improvements.
* Care should be taken not to exceed the input power
values noted above.

VU 05280 Printed in Malaysia

Downloaded from: http://www.usersmanualguide.com/

 This file has been downloaded from:

www.UsersManualGuide.com

User Manual and User Guide for many equipments like mobile phones, photo cameras, monther board, monitors, software, tv, dvd, and othes..

Manual users, user manuals, user guide manual, owners manual, instruction manual, manual owner, manual owner's, manual guide,
manual operation, operating manual, user's manual, operating instructions, manual operators, manual operator, manual product,
documentation manual, user maintenance, brochure, user reference, pdf manual

Downloaded from: http://www.usersmanualguide.com/