Scribd
Upload
68 views4 pages

Tutorial 2 - Cisco Packet Tracer

ok

Uploaded by

Muhammad Murtaza
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
68 views4 pages

Tutorial 2 - Cisco Packet Tracer

ok

Uploaded by

Muhammad Murtaza
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

ICT504 Tutorial 2- Individual

ICT504
IT Networking and Communication
Tutorial 2: Getting Started with Cisco Packet Tracer (Part
A) and OSPF (Part B)
2 + 8 = 10 Marks

March 2024

Page 1
ICT504 Tutorial 2- Individual

Getting Started with Cisco Packet Tracer (Part A)

Please complete Activity 6 and submit the course completion badge. The badge's name
should match your VIT's name. Therefore, ensure you provide your full name while
registering. In case of mismatching, you won't receive any marks.

OSPF and ACL (Part B)


Download the Tutorial 2—Cisco packet Tracer file from the LMS. Open it in the Cisco
packet tracer. It’s the basic topology; you can use it to complete Part B. Please make sure
all the devices have your student ID. You must submit the Word file showing all the
configuration and verification with screenshots and a completed Cisco packet tracer file.
All the devices should be renamed to your Student ID. You won't receive any marks if you
don't submit the Word and Cisco packet tracer files.
You may use the links below to learn about OSPF and ACL.
https://networklessons.com/ospf/basic-ospf-configuration
https://www.9tut.com/access-list-tutorial

The goal is to practice using the basic commands of OSPF and standard ACLs. Please do
the following configurations:

1. - Configure the IP addresses as:

- Host A: 10.1.1.1/24. Gateway: 10.1.1.3


- Host B: 10.1.1.2/24. Gateway: 10.1.1.3
- R1´s G0/0: 10.1.1.3/24
- Host C: 10.3.3.3/25. Gateway: 10.3.3.1
- R1´s G0/1: 10.3.3.1/25
- S1: 10.2.2.1/24. Gateway: 10.2.2.3
- S2: 10.2.2.2/24. Gateway: 10.2.2.3
- R2´s G0/0: 10.2.2.3/24
- R1´s S0/3/0: 10.4.4.1/30
- R2´s S0/3/0: 10.4.4.2/30

Page 2
ICT504 Tutorial 2- Individual

Check that you can ping between hosts in the same subnet:

- From Host A to Host B.


- From Host C to R1´s G0/1 interface.
- From S1 to S2.
- From R1´s S0/3/0 interface to R2´s S0/3/0 interface.

Note that you can´t ping between hosts in different subnets because the routers don´t have
any entry in their routing table.

2. – Enable OSPF in all interfaces, both R1 and R2 (area 0), with only one subcommand in
the OSPF configuration.

Check that the neighboring relationships have been created between R1 and R2.

Check that, after configuring OSPF, you can ping between hosts in different subnets.

- From Host A to Host C.


- From Host C to S1.
- From Host A to S1.

3. – Configure ACL on the right routers, interfaces and directions based on these
requirements:

- Permit packets from S1 going to subnet of hosts A and B.


- Deny packets from S2 going to subnet of host A and B.
- Permit packets from S2 going to subnet of host C.
- Deny packets from S1 going to subnet of host C.

After configuring ACL, check that:

- You can ping from S1 to host A and B, but not to host C.


- You can ping from S2 to host C, but not to hosts A and B.

Page 3
ICT504 Tutorial 2- Individual

5.1 Marking Guide:

Tutorial Not Submitted. Or Excellent:


2 – Part Totally Inaccurate Or Course
A Academic Misconduct. completion
0 Points Badge
submitted with
valid
credentials.
2 Points
Tutorial Not Submitted. Or Unacceptable: Acceptable: Good: Excellent: Totally
2 – Part Totally Inaccurate Or Inaccurate and Somewhat Mostly accurate and complete
B Academic Misconduct. incomplete; accurate and accurate lab report; all tasks
0 Points many complete; more and relevant screenshots
inconsistencies. than a few complete. are provided with
2 points inconsistencies, All necessary
errors or required headings/explanations.
screenshots of screenshots 8 Points
all tasks are not are
provided. available
4 points for given
tasks.
6 points

Page 4

You might also like