Printed Page: 1 of 2

Subject Code: KEE101T

0Roll No: 0 0 0 0 0 0 0 0 0 0 0 0 0

B.TECH
(SEM I ) THEORY EXAMINATION 2020-21
BASIC OF ELECTRICAL ENGINEERING
Time: 3 Hours Total Marks: 100
Note: 1. Attempt all Sections. If require any missing data; then choose suitably.

SECTION A
1. Attempt all questions in brief. 2 x 10 = 20
Qno. Question Marks CO
a. Define ideal voltage and current source. 2 1
b. Define Active and Passive Elements. 2 1
c. Define Form factor and Peak Factor. 2 2
d. Classify the losses in transformer. 2 3
e. Explain True power, reactive power and Apparent power 2 3
f. What is meant by the term speed regulation 2 4
g. Why transformer is not used on DC 2 4
h. Define the term slip 2 4
i. Write down the application of Synchronous Motor. 2 4
j. Write application of Single Phase Induction Motor. 2 4
9
02

50
SECTION B
0E

2. Attempt any three of the following:

6.
Qno. Question Marks CO

18
P2

a. Apply mesh analysis , obtain the current through 5 ohm resistance in the 10 1

7.
_Q

following circuit

.7
TU

03
|1
AK

19
0:
:1
09

b. Obtain equivalent Star from Delta in Star-Delta Transformation 10 1

c. Derive expression for average value and RMS value of Half wave 10 2
1

rectifier voltage output.

02

d. Why Single Phase induction motor is not self starting. What are different 10 3
-2

methods to make self starting. Explain one of them

ar

e. A balanced star connected load of (6+j8) ohm per phase connected to a 10 3

M

balance 3 phase, 400V supply. Find the line current, power factor, power
and total volt-amperes.
2-
|1

SECTION C
3. Attempt any one part of the following:
Qno. Question Marks CO
a. Show the condition for resonance in a parallel R-L-C circuit. State the 10 2
application of series.
b. If load draws a current of 10A at 0.8 p.f lagging, when connected to 100 10 2
volt supply, calculate the values of real, reactive and apparent powers.
And also find the resistance of load.

AKTU_QP20E029 | 12-Mar-2021 09:10:19 | 103.77.186.50

 Printed Page: 2 of 2
Subject Code: KEE101T
0Roll No: 0 0 0 0 0 0 0 0 0 0 0 0 0

4. Attempt any one part of the following:

Qno. Question Marks CO
a. Using Thevenin Theorem , Determine the current through 6 ohm 10 1

b. Find the equivalent resistance of the following circuit and calculate the 10 1
current supplied by source.

9
02

50
0E

6.
18
P2

7.
_Q

.7
5. Attempt any one part of the following:
TU

a. Derive the Emf equation of single phase transformer. A single phase

03 10 3
100KVA, 6.6kV/230 V, 50 Hz, transformer has 90% efficiency at 0.8
|1
AK

Lagging power factor both at full load and also at half load. Determine
19

iron and copper loss at full load for transformer.

b. Derive the relationship between line current, Phase current, line voltage 10 3
0:

and phase voltage in a 3-phase star-connected and delta connected

:1

circuits.
09

6. Attempt any one part of the following:

a. A 4-Pole , 3 phase induction motor runs at 1440 rpm. Supply voltage is 10 4
1
02

500 V at 50 Hz. Mechanical power output is 20.3 Hp and mechanical

loss is 2.23 Hp. Calculate: (i) Mechanical Power Developed
-2

(ii) Rotor Cu Loss

ar

(iii) Efficiency
M

b. Draw and explain the Torque-Slip Characteristics of Three Phase 10 4

2-

Induction Motor.
|1

7. Attempt any one part of the following:

a. Explain 10 5
(i) MCB
(ii) ELCB
(iii)MCCB
b. Explain different types of Wires and Cables. 10 5

AKTU_QP20E029 | 12-Mar-2021 09:10:19 | 103.77.186.50