Scribd
Upload
58 views1 page

Lab Document - NetSim Online

Uploaded by

Kamal Mouhtadi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
58 views1 page

Lab Document - NetSim Online

Uploaded by

Kamal Mouhtadi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

21/11/2023 23:16 Lab Document - NetSim Online

Lab ID: NSO.A624J349.DEMO.2

NetSim Demo Lab: Configuration Demo I


Introduction
The demo version of Boson NetSim will execute only the limited command set required to complete this lab. You will
need to purchase a licensed version in order to access all of the commands supported by Boson NetSim. To purchase
a licensed version of Boson NetSim, please visit Boson.com.

An introductory video is available on Boson's YouTube channel that demonstrates how to use the Boson NetSim
software. If you have not used Boson NetSim before, this video is a great way to get started; if you recently upgraded
NetSim, the video will show you the difference in the user interfaces.

Objective
Configure RouterA so that PC1 and PC2 will be able to communicate with PC3 and PC4. Then log on to the console
of PC1 and PC2, and ping PC3 and PC4. The configuration for RouterB, SwitchA, SwitchB, and all four PC hosts has
already been completed.

Lab Topology
The topology for this lab contains three networks: the 10.1.1.4/30 wide area network (WAN) that contains the serial
interfaces that connect RouterA and RouterB, the 192.168.100.0/24 local area network (LAN) that connects PC1 and
PC2 to the FastEthernet 0/0 interface of RouterA, and the 192.168.200.0/24 LAN that connects PC3 and PC4 to the
FastEthernet 0/0 interface of RouterB. Enhanced Interior Gateway Routing Protocol (EIGRP) is used to exchange
routing table updates between RouterA and RouterB.

The topology diagram below represents the NetMap in the Simulator. To access each of the devices from within the
Simulator, select the device name from the Devices pane or open the lab topology and double-click a device to
display that device’s console locally.

Command Summary
Command Description
clock rate clock-rate sets the clock rate for a Data Communications Equipment
(DCE) interface
configure terminal enters global configuration mode from privileged EXEC
mode
enable enters privileged exec mode
end ends and exits configuration mode
exit exits one level in the menu structure

https://netsim.boson.com/document/f274d4b0-8322-4d79-a974-4b920ca620c1 1/1

You might also like