Scribd
Upload
20 views4 pages

RTWP Troubleshooting Guide For WCDMA-NodeB-Huawei

Uploaded by

meghdad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
20 views4 pages

RTWP Troubleshooting Guide For WCDMA-NodeB-Huawei

Uploaded by

meghdad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

INTERNAL

RTWP Troubleshooting Guide for WCDMA NodeB

Arief Miftahur
Prepare by Date Mar 2014
Rohman

2024-06-08 Huawei Proprietary - Restricted Distribution Page1, Total4


INTERNAL

1. Introduction
RTWP Stands for Received Total Wideband Power. Meaning the total level of noise
within the UMTS frequency band of any cell. The general value of received total
wide band power (RTWP) is around -106 (+-4 dBm).

Example Poor RTWP:

Example Normal RTWP:

2024-06-08 Huawei Proprietary - Restricted Distribution Page2, Total4


INTERNAL

2. Factors Influencing RTWP


a. Configuration Issue
Engineer create the integration script not match with parameter design from RNP
b. Installation not good/Hardware faulty
Sometimes hardware faulty (Feeder, jumper, WRFU, RF) and installation not
good. It will be impact to RTWP
c. Internal or External Interference
 Internal Interference: Interference caused due to the physical equipment like
hardware issues in sites which include RF units, Antenna systems, Combiner
units and improper feeder cable connections will also result in High RTWP.
 External Interference: Interference caused by CDMA operators or military
camps using the frequency close to our 3G frequencies which in turn results
in High RTWP.

3. Alarms related to RTWP:


a. RF Unit RX Channel RTWP / RSSI Unbalanced
b. RF Unit RX Channel RTWP / RSSI Too Low

4. RTWP Handling:
1.Check RTWP value from M2000: Performance -> Query result -> BSC6900 UMTS
-> Measurements related to Measurement Report -> Cell TX and RX Power

2024-06-08 Huawei Proprietary - Restricted Distribution Page3, Total4


INTERNAL

Measurement Per Cell


2.Compare RTWP value at day time (busy hour) and at night time (Non busy hour)
3.Make sure hardware and installation OK
4.Change the azimuth after get agreement and confirmation from RNP/O team
5.If RTWP value still poor, check maybe have Internal or External Interference
6.For Internal or External interference please communication with NPO team

THANK YOU

2024-06-08 Huawei Proprietary - Restricted Distribution Page4, Total4

You might also like