EMUBT Setup Manual
EMUBT Setup Manual
3 At first start EMUBT will ask to select a directory where all necessary files will be stored:
debug files, application settings, application status, your binary files etc.
Also windows may notify that this application is not verified, you can disable this
warning .
4 Windows Directory browser will appear, select the destination folder or create new with
the browser, click “Choose Folder” (this may differ in different windows versions). The
browser will disappear, start EMUBT again… In selected folder new files and folders will
appear.
5 EMUBT will autmatically try to find EMUBT bluetooth device, you will see DISCOVERY
button blinking. It may take 30s, and sometimes it fails, you can retry several times or
add EMUBT bluetooth device in Windows bluetooth manager.
Important: If you installed EMUBT board in ECU, ignition must be on to power up the
device and Bluetooth module as well, it is quite obvious but worth mentioning :)
6 It saved device port and address to configuration file, you can modify this settings by
clicking “Config” button, changing the settings as you wish and Apply
7 Now you are ready to connect to the board, click Connect button
First connection is always tricky… you may have to try several times. Basically it is
expected that Windows will show information that Bluetooth device is trying to connect
You should click this box marked on red and provide paring PIN number:
PIN: 1234
Click “Next”. It is recommended that at this step you have internet connection.
Windows may try to update COM port drivers for Bleutooth, it really may be crucial if
you fail connecting to EMUBT board at next step. It should say that adding Bluetooth
device was completed successfully.
8 Test your connection. EMUBT should be able to connect to the board just after
providing the PIN in Windows, if not you can close EMUBT.exe and open it again.
To connect click “Connect” button...
It should say:
connected to emu device
digidiag disabled
Digidiag: digifant diagnostics – this procedure sends ECU engine data to my board.
Digidiag must be disabled because the data send from ECU will interfere with data
exchange between the board and EMUBT.exe. When you close EMUBT or disconnect it
will restore digidag and verify if it works.
9 And that’s it. You can see how it works by clicking READ button. It should download
binary file from the board
In next manual you will find overview of most of EMUBT
functions, buttons and emulation options.