Scribd
Upload
26 views2 pages

Bosch Aoftware

Bosch software

Uploaded by

eng.midoo6u
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
26 views2 pages

Bosch Aoftware

Bosch software

Uploaded by

eng.midoo6u
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Solution 2000/3000 firmware update guide

How to Check your COM Port

From your windows control panel, open device manager, select


Ports (COM & LPT), Right click on the USB to UART Bridge.
2 Click on ‘Port Settings’ then ‘Advanced’

1 Right click on ‘Silicon Labs CP210x USB to UART


Bridge (COM-X)’

Click here

Right click

Then click here

Key: X = Your COM number

3 Set the COM port between 1 & 4

If you cannot see anything under Ports (COM &


LPT) or you get an unknown device, you need
to install the USB drivers (default is c:\Program
Files (x86)\Bosch Security Systems\A-Link Plus\
USB_DRIVER\DLA) select either the X86 or X64
file depending on your PC. Once you have done
this you need to restart your PC and try again.
Click the drop-down and select

Direct Link File Management

1 Run DLA Download Tool (dlfm.exe) from within


the A-Link Plus installation directory 2 Select the COM port of the DLA from the pull
down box in the menu
(default is c:\Program Files (x86)\Bosch
Security Systems\A-Link Plus)
3 Click on the connect icon
4 Click on the icon and start write update file to
direct link box

3 3
If there is an existing firmware file on the DLA, you can
click X to delete it. Once the correct firmware has been loaded onto the
DLA, close the DLA Download Tool and disconnect the
If you need to replace the firmware on the DLA, click DLA from the Laptop/PC.
on Add/Replace and then select the firmware file.

Hint: Panel firmware update file should end in .update and not .ZIP

Update Firmware

Note: Although the firmware update process will not


change any of the settings on the panel, it is advisable
to backup the panel programming using the A-Link Plus
software or the Direct Link Adapter prior to updating
panel firmware.

1. Disconnect mains power and battery.

2. Connect the direct link adapter to the panel.

3. Hold “default” button on the panel PCB.

4. Power up panel.

5. Wait about 4 to 5 seconds (panel heart beat light will


illuminate solid – button can be released at this
point). Once the heart beat light begins flashing
(normally 2 to 3 minutes) the operation is complete.

6. Power off and disconnect direct link box.

7. Power up the panel.

Copyright © 2017 — In the interest of ongoing product improvement we reserve the right to change specifications at any time without notice — E&OE 12/17

You might also like