Page 1/6

Safety data sheet

according to 1907/2006/EC, Article 31
Printing date 24.02.2012 Revision: 24.02.2012

1 Identification of the substance/mixture and of the company/undertaking

· Product identifier
· Trade name: Multi Purpose EP00
· Relevant identified uses of the substance or mixture and uses advised against
· Application of the substance / the preparation LUBRICATING GREASE
· Details of the supplier of the safety data sheet
· Manufacturer/Supplier:
Gem Oils Limited
Regaskin
Cavan
Ireland

Tel: +353 (0) 49 4331077

Fax: +353 (0) 49 4368329
e-mail: [email protected]
· Further information obtainable from: Product safety department.
· Emergency telephone number: Tel: +353 87 6867268

2 Hazards identification
· Classification of the substance or mixture
· Classification according to Regulation (EC) No 1272/2008
The product is not classified according to the CLP regulation.
· Classification according to Directive 67/548/EEC or Directive 1999/45/EC Not applicable.
· Information concerning particular hazards for human and environment:
The product does not have to be labelled due to the calculation procedure of the "General Classification
guideline for preparations of the EU" in the latest valid version.
· Classification system:
The classification is according to the latest editions of the EU-lists, and extended by company and
literature data.
· Label elements
· Labelling according to Regulation (EC) No 1272/2008 Void
· Hazard pictograms Void
· Signal word Void
· Hazard statements
Safety data sheet available on request.
· Other hazards
· Results of PBT and vPvB assessment
· PBT: Not applicable.
· vPvB: Not applicable.

3 Composition/information on ingredients
· Chemical characterization: Mixtures
· Description: A blend of highly refined mineral oils and multifunctional additives with thickener system.
· Dangerous components:
Zinc alkyldithiophosphate 2.5%
Xi R36; N R51/53
Aquatic Chronic 2, H411; Eye Irrit. 2, H319
· Additional information: For the wording of the listed risk phrases refer to section 16.
IE
(Contd. on page 2)

34.0.9
 Page 2/6
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 24.02.2012 Revision: 24.02.2012

Trade name: Multi Purpose EP00

(Contd. of page 1)

4 First aid measures

· Description of first aid measures
· General information: No special measures required.
· After inhalation: Supply fresh air; consult doctor in case of complaints.
· After skin contact:
Immediately wash with water and soap and rinse thoroughly.
If skin irritation continues, consult a doctor.
· After eye contact:
Check for and remove any contact lenses.
Rinse opened eye for several minutes under running water. Then consult a doctor.
· After swallowing:
Wash mouth out with water
Do not induce vomiting; call for medical help immediately.
· Information for doctor:
High pressure injection injuries through the skin require prompt surgical intervention and possibly
steroid therapy, to minimise tissue damage and loss of function. Because entry wounds are small and do
not reflect the seriousness of the underlying damage, surgical exploration to determine the extent of
involvement may be necessary. Local anaesthetics or hot soaks should be avoided because they can
contribute to swelling, vasospasm and ischaemia. Prompt surgical decompression, debridement and
evacuation of foreign material should be performed under general anaesthetics, and wide exploration is
essential.
· Most important symptoms and effects, both acute and delayed
No further relevant information available.
· Indication of any immediate medical attention and special treatment needed
No further relevant information available.

5 Firefighting measures
· Extinguishing media
· Suitable extinguishing agents:
CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
· For safety reasons unsuitable extinguishing agents: Water with full jet
· Special hazards arising from the substance or mixture No further relevant information available.
· Advice for firefighters
· Protective equipment:
Wear self-contained respiratory protective device.
Wear fully protective suit.

6 Accidental release measures

· Personal precautions, protective equipment and emergency procedures
Particular danger of slipping on leaked/spilled product.
· Environmental precautions:
Do not allow to penetrate the ground/soil.
Do not allow to enter sewers/ surface or ground water.
· Methods and material for containment and cleaning up:
Pick up mechanically.
Send for recovery or disposal in suitable receptacles.
· Reference to other sections No dangerous substances are released.
IE
(Contd. on page 3)

34.0.9
 Page 3/6
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 24.02.2012 Revision: 24.02.2012

Trade name: Multi Purpose EP00

(Contd. of page 2)

7 Handling and storage

· Handling:
· Precautions for safe handling
Prevent formation of aerosols.
Ensure good ventilation/exhaustion at the workplace.
· Information about fire - and explosion protection: No special measures required.
· Conditions for safe storage, including any incompatibilities
· Storage:
· Requirements to be met by storerooms and receptacles: Prevent any seepage into the ground.
· Information about storage in one common storage facility: Store away from oxidizing agents.
· Further information about storage conditions:
Store in cool, dry conditions in well sealed receptacles.
· Specific end use(s) No further relevant information available.

8 Exposure controls/personal protection

· Additional information about design of technical facilities: No further data; see item 7.
· Control parameters
· Ingredients with limit values that require monitoring at the workplace:
MINERAL OIL highly & severely refined (inhalable)
TLV Short-term value: 5 ppm
· Additional information: The lists valid during the making were used as basis.
· Exposure controls
· Personal protective equipment:
· General protective and hygienic measures:
Wash hands before breaks and at the end of work.
Do not eat, drink, smoke or sniff while working.
Do not carry product impregnated cleaning cloths in trouser pockets.
Avoid close or long term contact with the skin.
Avoid contact with the eyes.
Do not inhale gases / fumes / aerosols.
· Respiratory protection: Not required.
· Protection of hands:
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
· Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer. As the product is a preparation of several
substances, the resistance of the glove material can not be calculated in advance and has therefore to be
checked prior to the application.
· Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to
be observed.
· Eye protection: Safety glasses
· Body protection: Oil resistant protective clothing
IE
(Contd. on page 4)

34.0.9
 Page 4/6
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 24.02.2012 Revision: 24.02.2012

Trade name: Multi Purpose EP00

(Contd. of page 3)

9 Physical and chemical properties

· Information on basic physical and chemical properties
· General Information
· Appearance:
Form: Pasty
Colour: Brown
· Odour: Mineral-oil-like
· Change in condition
Melting point/Melting range: Undetermined.
Boiling point/Boiling range: Undetermined.
· Flash point: > 100°C
· Ignition temperature: >250°C
· Self-igniting: Product is not selfigniting.
· Danger of explosion: Product does not present an explosion hazard.
· Density at 20°C: 0.83 g/cm³
· Solubility in / Miscibility with
water: Not miscible or difficult to mix.
· Viscosity:
Kinematic: Not determined.
· Other information No further relevant information available.

10 Stability and reactivity

· Reactivity
· Chemical stability
· Thermal decomposition / conditions to be avoided:
No decomposition if used and stored according to specifications.
· Possibility of hazardous reactions No dangerous reactions known.
· Conditions to avoid No further relevant information available.
· Incompatible materials: Strong oxidising agents.
· Hazardous decomposition products: Carbon monoxide and carbon dioxide

11 Toxicological information
· Information on toxicological effects
· Acute toxicity:
· Primary irritant effect:
· on the skin: No irritant effect.
· on the eye: No irritating effect.
· Sensitization: No sensitizing effects known.
· Additional toxicological information:
The product is not subject to classification according to the calculation method of the General EU
Classification Guidelines for Preparations as issued in the latest version.
When used and handled according to specifications, the product does not have any harmful effects to our
experience and the information provided to us.
IE
(Contd. on page 5)

34.0.9
 Page 5/6
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 24.02.2012 Revision: 24.02.2012

Trade name: Multi Purpose EP00

(Contd. of page 4)

12 Ecological information
· Toxicity
· Aquatic toxicity: No further relevant information available.
· Persistence and degradability Inherently biodegradable
· Behaviour in environmental systems:
· Bioaccumulative potential Product is not expected to bioaccumulate.
· Mobility in soil No further relevant information available.
· Additional ecological information:
· General notes:
Water hazard class 1 (German Regulation) (Self-assessment): slightly hazardous for water
Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage
system.
· Results of PBT and vPvB assessment
· PBT: Not applicable.
· vPvB: Not applicable.
· Other adverse effects No further relevant information available.

13 Disposal considerations
· Waste treatment methods
· Recommendation
Must not be disposed together with household garbage. Do not allow product to reach sewage system.
Contact waste processors for recycling information.
Delivery of waste oil to offically authorized collectors only.
Used, degraded or contaminated product may be classified as hazardous waste. Anyone classifying
hazardous waste and determining its fate must be qualified in accordance with state and international
legislation.
· European waste catalogue
13.02.05 (if product has been used exclusively as a mineral based non-chlorinated engine or gear
lubricating oil, or as a mineral based non-chlorinated lubricating grease)
· Uncleaned packaging:
· Recommendation: Disposal must be made according to official regulations.

14 Transport information
· UN-Number
· ADR, ADN, IMDG, IATA Void
· UN proper shipping name
· ADR, ADN, IMDG, IATA Void
· Transport hazard class(es)
· ADR, ADN, IMDG, IATA
· Class Void
· Packing group
· ADR, IMDG, IATA Void
· Environmental hazards:
· Marine pollutant: No
· Special precautions for user Not applicable.
(Contd. on page 6)
IE

34.0.9
 Page 6/6
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 24.02.2012 Revision: 24.02.2012

Trade name: Multi Purpose EP00

(Contd. of page 5)

· Transport in bulk according to Annex II of

MARPOL73/78 and the IBC Code Not applicable.
· Transport/Additional information: Not dangerous according to the above specifications.
· UN "Model Regulation": -

15 Regulatory information
· Chemical safety assessment: A Chemical Safety Assessment has not been carried out.

16 Other information
This information is based on our present knowledge. However, this shall not constitute a guarantee for
any specific product features and shall not establish a legally valid contractual relationship.
· Relevant phrases
H319 Causes serious eye irritation.
H411 Toxic to aquatic life with long lasting effects.
R36 Irritating to eyes.
R51/53 Toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment.
· Department issuing MSDS: Product safety department.
· Contact:
IE

34.0.9
 TECHNICAL DATA
SHEET

MP 00EP GREASE
Semi-fluid multi purpose grease for Typical Test Data:
use in selected industrial equipment
and automotive gearboxes Colour Green/brown
Appearance Smooth semi-
Product Description: fluid grease
NLGI Classification 00
GEM MP 00EP is a premium quality grease Soap Base Lithium
prepared from refined base oils and lithium
Un-worked Penetration
hydroxy stearate soap thickener. 400-430
(IP50)
GEM MP 00EP grease contains oil soluble EP Worked Penetration (IP50) 400-430
additives to provide protection against seizure Copper corrosion (IP 112) 1b
under highly loaded service conditions. The Operating temperature OC -30 to 110
grease also contains additives to inhibit Drop Point OC (IP132) N/A
oxidation and rust. Base oil Viscosity @ 40°C 150 cSt
Mean Hertz load 58
GEM MP 00EP grease is particularly suited for
use in industrial equipment and in some Four ball weld load (Kgs) 315
automotive gear box applications. The grease Timken OK Load Kg 20
is easily pumped over long distances, even at
low temperatures. Health & Safety: (Group 10)

Benefits: Please refer to the relevant MSDS which is


available to all customers.


Excellent pumpability


Good oxidation stability Availability:

Good corrosion protection


Usable over a wide temperature range Available in 50 kg, 12.5 kg and 3 kilo kegs.
Good load carrying capabilities

Application:
GEM MP 00EP is recommended for use in
industrial equipment and in some automotive
gear box applications where a semi fluid grease
of this type is called for.

For further information please contact your

local representative or GEM Oils directly.

Gem Oils Limited

Regaskin
Cavan
Rev 003 Date 27-11-2015 Ireland
Tel +353 (0) 49 4331077
Fax +353 (0) 49 4368329