Scribd
Upload
7 views

The Command Service Network Restart

Uploaded by

GEORGE VICTORIA
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
7 views

The Command Service Network Restart

Uploaded by

GEORGE VICTORIA
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

The command service network restart is used to restart the network services on a

Linux system. This can be necessary after making changes to network configurations,
such as updating IP addresses, modifying DNS settings, or changing network interfaces.

Running the Command

To execute the command, you typically need superuser privileges. Here’s how you can
do it:

1. Open a terminal.
2. Run the command with sudo for root privileges:

bash
Copy code
sudo service network restart

Notes on Different Systems

 Red Hat/CentOS/Fedora: These distributions use systemd, so the equivalent


command would be:

bash
Copy code
sudo systemctl restart network

 Debian/Ubuntu: For these distributions, you might use:

bash
Copy code
sudo systemctl restart networking

 Older Systems: On older systems that do not use systemd, the service
command as shown above is appropriate.

Potential Impact

Restarting the network service will temporarily disrupt network connectivity. This can
affect all network-related activities and services running on the machine. Ensure that
this action will not disrupt critical services or active connections unnecessarily.

Troubleshooting

If the network does not come back up properly after restarting, you can:

 Check the status of the network service:

bash
Copy code
sudo systemctl status network
 Review network configuration files for errors (e.g., /etc/network/interfaces
on Debian/Ubuntu or /etc/sysconfig/network-scripts/ifcfg-* on Red
Hat-based systems).
 Look at relevant logs, such as /var/log/syslog or /var/log/messages, for
clues on what might have gone wrong.

Alternative Approaches

For changes that require minimal disruption, you can sometimes apply configurations to
individual interfaces without restarting the entire network service. For example, using
ifup and ifdown commands on Debian-based systems:

bash
Copy code
sudo ifdown eth0 && sudo ifup eth0

Or using nmcli for NetworkManager-managed connections:

bash
Copy code
sudo nmcli connection down <connection_name>
sudo nmcli connection up <connection_name>

This approach can help isolate changes to specific interfaces, reducing overall
downtime.

You might also like