Scribd
Upload
29 views2 pages

Powder Flow Calc

Uploaded by

Indra BR
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
29 views2 pages

Powder Flow Calc

Uploaded by

Indra BR
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Sheet1

DO NOT USE THIS METHOD FOR DETAIL DESIGN – ALWAYS CONSULT A REPUTABLE SUPPLIER FOR DETAIL DE
THIS TOOL IS GIVEN ONLY TO ILLUSTRATE THE EXAMPLE DONE IN THE WEBSITE. USING IT FOR ANY OTHER P

Powder Flowability estimation To modify Calculated

This calculation sheet is allowing to calculate the angle or repose, the Carr Index and the Hausner ratio which are

Angle of repose Carr Index and Hausner ratio

Loose bulk density


Tapped bulk density

Carr Index
Hausner ratio

Good flowability ? Please refer

Height of the heap 10 mm


Radius of the heap 20 mm
Angle of repose calculated 26.6 degrees

Good flowability ? Please refer to below table

If you spot a mistake or wish to suggest an improvement, please contact [email protected]

Copyright www.PowderProcess.net

The content of PowderProcess.net is copyrighted but no warranty nor liability is ensured. The content of this site is to be seen as a help and important information and
the quality procedure of his organization or by checking another source. The user must always respect all applicable regulation. The use of the information is a

FOR EDUCATIONAL PURPOSE ONLY – DO NOT USE THIS METHOD FOR DETAIL DESIGN – ALWAYS CONSULT A

Page 1
Sheet1
E SUPPLIER FOR DETAIL DESIGN
USING IT FOR ANY OTHER PURPOSE IS AT OWN RISK OF USER

the Hausner ratio which are indicative of the flowability of bulk solids

Carr Index and Hausner ratio

oose bulk density ρbulk 450 kg/m3


apped bulk density ρtapped 572 kg/m3

Carr_Index 21.3
H 1.3

Good flowability ? Please refer to below table

[email protected]

seen as a help and important information and calculation must always be double checked by the user through
able regulation. The use of the information is at the user and its organization own risk and own cost.

IGN – ALWAYS CONSULT A REPUTABLE SUPPLIER FOR DETAIL DESIGN

Page 2

You might also like