Scribd
Upload
58 views2 pages

Power Quality Q4

The document is a test paper on power quality for an engineering course. It contains 11 questions across various topics related to power quality, voltage sags, interruptions, harmonics, and monitoring and mitigation of power quality issues. The questions cover definitions, explanations of concepts, calculations, and discussions of procedures and equipment behavior under different power quality conditions.

Uploaded by

Shiva Glenn
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
58 views2 pages

Power Quality Q4

The document is a test paper on power quality for an engineering course. It contains 11 questions across various topics related to power quality, voltage sags, interruptions, harmonics, and monitoring and mitigation of power quality issues. The questions cover definitions, explanations of concepts, calculations, and discussions of procedures and equipment behavior under different power quality conditions.

Uploaded by

Shiva Glenn
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Code No: 137FV R16

JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD


B. Tech IV Year I Semester Examinations, January/February - 2023
POWER QUALITY
(Electrical and Electronics Engineering)
JN
Time: 3 Hours Max. Marks: 75

Note: i) Question paper consists of Part A, Part B.


ii) Part A is compulsory, which carries 25 marks. In Part A, Answer all questions.
TU
iii) In Part B, Answer any one question from each unit. Each question carries 10 marks
and may have a, b as sub questions.

PART – A
H
(25 Marks)
1.a) Define voltage quality. [2]
b) Explain harmonic current distortion. [3]
U
c) What are the multiple events? [2]
d) What is the difference between medium and low voltage systems? [3]
se
e) Define voltage sag. [2]
f) Explain the load influence on voltage sags. [3]
g) Define voltage tolerance. [2]
d
h) What is the need for study the equipment behavior under voltage sag conditions? [3]
i) What is the purpose of standardization? [2]
j) Elaborate the European voltage characteristics standards. [3]
pa
PART – B
(50 Marks)
pe
2. Explain the following: a) harmonics b) noise c) notching d) dc-offsets
e) Fluctuations and f) Flicker. [10]
OR
rs
3. Discuss various remedies to improve power quality. [10]

4. Discuss the origin of interruptions. [10]


20
OR
5.a) Explain the monitoring of short interruptions.
b) What is single phase tripping? Explain. [5+5]
23
6. Explain the procedure of voltage sag calculation in non-radial systems. [10]
OR
7. What are phase angle jumps? Explain the origin of phase angle jumps associated with
voltage sags. [10]
8. Explain the behavior of power electronic loads under voltage sag conditions. [10]
OR
9. Explain the operation of adjustable speed D.C drives under voltage sag conditions.[10]
JN
10. Explain the operation of combined shunt and series controller. [10]
OR
11. What are PQ surveys? Explain them. [10]
TU
---ooOoo---
H
U
se
d
pa
pe
rs
20
23

You might also like