JTP-309 User's Guide

Download as pdf or txt
Download as pdf or txt
You are on page 1of 1

JTP-309 AUTOMATIC MAINS FAILURE UNIT USER’S GUIDE Parameter

Mains V. Low Lim


Default Value
170
Function
Adjust Mains Voltage Low Limit
Mains V. Hig. Lim 270 Adjust Mains Voltage High Limit
1. How to Enter Program Menu Gen.V. Low Limit 170 Adjust Generator Voltage Low Limit
Gen.V. Hig Limit 270 Adjust Generator Voltage High Limit
Freq.Low Limit 45 Adjust Frequency Lower Limit
Press OFF Button if not in OFF Freq.High Limit 57 Adjust Frequency Higher Limit
state. OFF button LED will turn on. Alarm Delay 3 Adjust Delay Time Before Alarm
Press OFF+MENU buttons and Crank Number 3 Adjust Crunk Trials
Wait Bef. Crank 3 Wait Before Crank in Seconds
hold for approximatelly 3 seconds. Wait Betw. Crank 10 Time Between Two Cranks in Seconds
PARAMETERS MENU will appear Crank Time 4 Maximum Crank Time in Seconds
on the screen. Now you are inside Stop Time 0 Stop Time If Stop Bobbin is Used in
Seconds
MENU of JTP309. Mains Wait Time 0.5 Mains Wait Time in Minutes
Cooling Time 0.5 Genset Cooling Time in Minutes
Before Stop
Mains.Cont.Time 4 Time Before Mains Contactor
Energized
Gense.Cont.Time 4 Time Before Genset Contactor
Energized
Spare Relay Fun Alarm Function of Spare Relay
Gen Start Delay 0 Waiting Time Before Genset Start
Gas Warning Lim 0 Fuel Warning Level (0 if not
functional)
Gas Stop Limit 0 Fuel Stop Limit (0 if not functional)
Choke Time 0 Time for Choke Function in Minutes
Oil Sens.In Typ Oil.G Oil Pressure Sensor Type (Level or
Gauge)
2. How to Change Parameters CT Ratio …./5
OverCurrent Lim
100
110
Current Transformer Ratio
Over Current Limit
Low Oil Pre.Limit 2 Low Oil Pressure Limit in Bar
When PARAMETERS MENU is Hi.Temp.War.Lim 90 High Temperature Warning Limit
printed on the screen press MENU Hi.Temp.Sto.Lim 95 High Temperature Stop Limit
Low Bat.Voltage 8 Low Battery Voltage Limit
button once. Parameters on the Hig.Bat.Voltage 50 High Battery Voltage Limit
first screen are printed on the Temp.Sens.Selec Vdo Coolant Temperature Sensor Type
display. First Parameter is Selection
Oil Temp Sensor Vdo Oil Temperature Sensor Type Selection
selected. Operating Mode 3 Ph. 1/3 Phase operating Mode Selection
Crank Tooth Num 20 Cranck Tooth Number for Magnetic
Pick-Up
Coolant Sensor In N.O. Coolant Sensor Input Selection
N.O/N.C.
Em.Stop Input N.O. Emergancy Stop Input Type N.O./N.C.
Oil Pr.Sens.Sel Vdo10 Oil Pressure Sensor Type Selection
Language Select ENG Language Selection
Time Adjust “Current Time” Adjust the Time of RTC
Date (Day/Month) “Current Date” Adjust Day and Month of RTC
Date (Year) “Current Year” Adjust Year of RTC
LCD Contrast 32 LCD Contarst Level
Srvice Time 0 Adjust Service Time to Generate
Warning

You might also like