Data sheet 6EP1332-4BA00

SIMATIC PM1507/1AC/24VDC/3A

SIMATIC PM 1507 24 V/3 A

Stabilized power supply for
SIMATIC S7-1500 input: 120/230
V AC, output: 24 V DC/3 A
Input
Input 1-phase AC
● Note Automatic range selection
supply voltage
● 1 at AC rated value 120 V
● 2 at AC rated value 230 V
input voltage
● 1 at AC 85 ... 132 V
● 2 at AC 170 ... 264 V
Wide-range input No
Overvoltage resistance 2.3 × Vin rated, 1.3 ms
Mains buffering at Vin = 93/187 V
Mains buffering at Iout rated, min. 20 ms; at Vin = 93/187 V
Rated line frequency 1 50 Hz
Rated line frequency 2 60 Hz
Rated line range 45 ... 65 Hz
input current
● at rated input voltage 120 V 1.4 A
● at rated input voltage 230 V 0.8 A
Switch-on current limiting (+25 °C), max. 23 A
duration of inrush current limiting at 25 °C
● maximum 3 ms
I²t, max. 1.3 A²·s
Built-in incoming fuse T 3,15 A/250 V (not accessible)
Protection in the mains power input (IEC 898) Recommended miniature circuit breaker: 10 A characteristic B or 6 A
characteristic C
Output
Output Controlled, isolated DC voltage
Rated voltage Vout DC 24 V
● output voltage at output 1 at DC rated value 24 V
Total tolerance, static ± 1%
Static mains compensation, approx. 0.1 %
Static load balancing, approx. 0.1 %
Residual ripple peak-peak, max. 50 mV

6EP13324BA00 Subject to change without notice

7.7.2021
Page 1/3 © Copyright Siemens
 Spikes peak-peak, max. (bandwidth: 20 MHz) 150 mV
product function output voltage adjustable No
Status display LED green for 24 V OK; LED red for error; LED yellow for stand-by
On/off behavior No overshoot of Vout (soft start)
Startup delay, max. 1.5 s
Voltage rise, typ. 10 ms
Rated current value Iout rated 3A
Current range 0 ... 3 A
supplied active power typical 72 W
short-term overload current
● on short-circuiting during the start-up typical 12 A
● at short-circuit during operation typical 12 A
duration of overloading capability for excess current
● on short-circuiting during the start-up 70 ms
● at short-circuit during operation 70 ms
Parallel switching for enhanced performance Yes
Numbers of parallel switchable units for enhanced 2
performance
Efficiency
Efficiency at Vout rated, Iout rated, approx. 87 %
Power loss at Vout rated, Iout rated, approx. 11 W
Closed-loop control
Dynamic mains compensation (Vin rated ±15 %), max. 0.1 %
Dynamic load smoothing (Iout: 50/100/50 %), Uout ± typ. 1%
Dynamic load smoothing (Iout: 10/90/10 %), Uout ± typ. 3%
Load step setting time 10 to 90%, typ. 5 ms
Load step setting time 90 to 10%, typ. 5 ms
setting time maximum 5 ms
Protection and monitoring
Output overvoltage protection Additional control loop, limitation (closed loop control) at < 28.8 V
Current limitation 3.15 ... 3.6 A
Current limitation, typ. 3.4 A
property of the output short-circuit proof Yes
Short-circuit protection Electronic shutdown, automatic restart
Overload/short-circuit indicator -
Safety
Primary/secondary isolation Yes
galvanic isolation Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178
and EN 61131-2
Protection class Class I
leakage current
● maximum 3.5 mA
● typical 0.4 mA
Degree of protection (EN 60529) IP20
Approvals
CE mark Yes
UL/cUL (CSA) approval cULus-Listed (UL 508, CSA C22.2 No. 142), File E143289
Explosion protection IECEx Ex nA nC IIC T4 Gc; ATEX (EX) II 3G Ex nA nC IIC T4 Gc;
cULus (ANSI/ISA 12.12.01, CSA C22.2 No.213) Class I, Div. 2, Group
ABCD, T4, File E330455
certificate of suitability NEC Class 2 No
FM approval Class I, Div. 2, Group ABCD, T4
CB approval Yes
certificate of suitability EAC approval Yes
Marine approval ABS, BV, DNV GL
EMC
Emitted interference EN 55022 Class B
Supply harmonics limitation EN 61000-3-2

6EP13324BA00 Subject to change without notice

7.7.2021
Page 2/3 © Copyright Siemens
 Noise immunity EN 61000-6-2
environmental conditions
ambient temperature
● during operation 0 ... 60 °C
— Note with natural convection
● during transport -40 ... +85 °C
● during storage -40 ... +85 °C
Humidity class according to EN 60721 Climate class 3K3, 5 … 95% no condensation
Mechanics
Connection technology Screw-/spring clamp connection
Connections
● Supply input L, N, PE: 1 screw terminal each for 0.5 ... 2.5 mm²
● Output L+, M: 2 spring-loaded terminals each for 0.5 to 2.5 mm²
product function
● removable terminal at input Yes
● removable terminal at output Yes
width of the enclosure 50 mm
height of the enclosure 147 mm
depth of the enclosure 129 mm
required spacing
● top 40 mm
● bottom 40 mm
● left 0 mm
● right 0 mm
Weight, approx. 0.45 kg
product feature of the enclosure housing can be lined up Yes
Installation Can be mounted onto S7-1500 rail
MTBF at 40 °C 1 611 993 h
other information Specifications at rated input voltage and ambient temperature +25 °C
(unless otherwise specified)

6EP13324BA00 Subject to change without notice

7.7.2021
Page 3/3 © Copyright Siemens