The document describes a solar panel mounting system called the Comp Mount. It is designed for installation on composition shingle roofs and provides superior waterproofing through an elevated water seal. The system is code compliant and comes with all necessary parts in an all-in-one kit.
The document describes a solar panel mounting system called the Comp Mount. It is designed for installation on composition shingle roofs and provides superior waterproofing through an elevated water seal. The system is code compliant and comes with all necessary parts in an all-in-one kit.
The document describes a solar panel mounting system called the Comp Mount. It is designed for installation on composition shingle roofs and provides superior waterproofing through an elevated water seal. The system is code compliant and comes with all necessary parts in an all-in-one kit.
The document describes a solar panel mounting system called the Comp Mount. It is designed for installation on composition shingle roofs and provides superior waterproofing through an elevated water seal. The system is code compliant and comes with all necessary parts in an all-in-one kit.
Encapsulating design raises the water seal 0.9” above roof deck
One-piece flashing with elevated cone – No
press-fits or deck-level EPDM washers to fail
WATERTIGHT FOR LIFE
Pegasus Solar’s Comp Mount is a cost effective, high-quality option for rail installations on composition shingle roofs. Designed to last decades, the one-piece flashing with elevated cone means there is simply nothing to fail.
25-year Warranty Superior Waterproofing
Manufactured with advanced materials and Tested to AC286 without sealant coatings to outlast the roof itself 0.9” elevated water seal
Code Compliant All-In-One Kit Packaging
Fully IBC/CBC Code Compliant Flashings, L-feet and SS lags with bonded Exceeds ASCE 7-10 Standards EPDM washers are included in each 24-pack
Pegasus Solar Inc 100 West Ohio Avenue, Richmond, CA 94804 T: 510.730.1343 www.pegasussolar.com COMP MOUNT
1. Drill pilot hole in 2. Optional: Apply a
center of rafter. “U-shape” of sealant to underside of flashing and position under 2nd shingle course, cone over pilot hole.
3. Place L-Foot over 4. Drive lag to required
cone and install lag embedment. Attach with washer through rail per rail L-Foot. manufacturer’s instructions.
9.0"
1.5" 1.9" 3.5" 3.5" 11.6" 0.9" 2.3" 2.3" 2.4"
Specifications Comp Mount Install Kit
SKU PSCR-C0 PSCR-U0 SPCR-CH
L-foot Type Closed Slot Open Slot Closed Slot
L-Foot, Flashing, 5/16” L-Foot, Flashing, 5/16” L-Foot, Flashing, 5/16” SS Lag Kit Contents SS Lag w/ EPDM washer SS Lag w/ EPDM washer w/ EPDM washer, M10 Hex Bolt
