Scribd
Upload
14 views

Additive 085

Uploaded by

Rajakumar Bhopale
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
14 views

Additive 085

Uploaded by

Rajakumar Bhopale
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

CALCIUM HYDROGEN PHOSPHATE

Prepared at the 19th JECFA (1975), published in NMRS 55B (1976) and in
FNP 52 (1992). Metals and arsenic specifications revised at the 63rd JECFA
(2004). A group MTDI of 70 mg/kg bw, as phosphorus from all food sources,
was established at the 26th JECFA (1982)

SYNONYMS Dibasic calcium phosphate, dicalcium phosphate, INS No. 341 (ii)

DEFINITION
Chemical names Calcium monohydrogen phosphate, calcium hydrogen orthophosphate,
secondary calcium phosphate

C.A.S. number 7757-93-9

Chemical formula Anhydrous: CaHPO4


Dihydrate: CaHPO4 · 2H2O

Formula weight Anhydrous: 136.06


Dihydrate: 172.09

Assay Not less than 98.0% and not more than the equivalent of 102.0% after drying

DESCRIPTION White crystals or granules, granular powder or powder

FUNCTIONAL USES Dough conditioner, yeast food

CHARACTERISTICS
IDENTIFICATION

Solubility (Vol. 4) Sparingly soluble in water; insoluble in ethanol

Test for calcium (Vol. 4) Passes test

Test for phosphate Passes test


(Vol. 4)

PURITY

Loss on drying (Vol. 4) Anhydrous: Not more than 2% (200o, 3 h)


Dihydrate: Not less than 18% and not more than 22% (200o, 3 h)

Fluoride (Vol. 4) Not more than 50 mg/kg (Method I or III)

Arsenic (Vol. 4) Not more than 3 mg/kg (Method II).

Lead (Vol. 4) Not more than 4 mg/kg


Determine using an atomic absorption technique appropriate to the specified
level. The selection of sample size and method of sample preparation may be
based on the principles of the method described in Volume 4, “Instrumental
Methods.”

METHOD OF Weigh accurately about 0.3 g of the sample, previously dried for 3 h at 200o.
ASSAY Dissolve in 10 ml of dilute hydrochloric acid TS, add about 120 ml of water and
a few drops of methyl orange TS, and boil for 5 min, keeping the volume and
pH of the solution in the beaker constant during the boiling period by adding
hydrochloric acid or water as necessary. Add 2 drops of methyl red TS and 30
ml of ammonium oxalate TS. Then add dropwise, with constant stirring, a
mixture of equal volumes of ammonia TS and water until the pink colour of the
indicator just disappears.

Digest on a steam bath for 30 min, cool to room temperature, allow the
precipitate to settle, and filter the supernatant liquid through an asbestos mat
in a Gooch crucible, using gentle suction. Swirl the precipitate in the beaker
with about 30 ml of a cold (below 20o) wash solution prepared by diluting 10 ml
of ammonium oxalate TS to 1000 ml. Allow the precipitate to settle, and pass
the supernatant through the filter. Repeat this washing by decantation three
more times. Using the wash solution, transfer the precipitate as completely as
possible to the filter. Finally, wash the beaker and the filter with to 10 ml
portions of cold (below 20o) water. Place the Gooch crucible in the beaker, and
add 100 ml of water and 50 ml of cold dilute sulfuric acid (1 in 6). Add from a
buret 35 ml of 0.1 N potassium permanganate, and stir until the colour
disappears. Heat to about 70o, and complete the titration with 0.1 N potassium
permanganate. Each ml of 0.1 N potassium permanganate is equivalent to
6.803 mg of CaHPO4.

You might also like