ES Railways Triple Track EN 1142 - Web

Download as pdf or txt
Download as pdf or txt
You are on page 1of 1

ES-Triple-Track-Railways

For Residential or Commercial Radiant Heating and Snow Melt Applications


Job Name Job Location Engineer Approval Contractor Approval Contractors P.O. No. Representative

Triple-Track Railways
Fastener for Heating PEX and Heating PEX-AL-PEX. Sizes:  1/2" (12.7 mm) Heating PEX 1/2" (12.7 mm) Heating PEX-AL-PEX

Specifications
Triple-Track Railways are used to secure 1/2" (12.7 mm) Heating PEX and 1/2" (12.7 mm) Heating PEX-AL-PEX tubing in concrete slab, thin slab, or sand bed applications where wire or rebar are not used. Tubing simply snaps into the appropriate sized clip to provide even pipe spacing. Triple-Track Railways are 4' (1.2 m) in length, molded from polypropylene and may be used whole or separated at 3" (76.2 mm) snap points. Specification Construction Molded Polypropylene Length *4' (1.2 m) Width 2-1/2" (63.5 mm) Weight 0.44 lb (0.20 kg) * May be separated into 3" (76.2 mm) section for custom spacing.

Triple-Track Railway

Installation Parameters
Heating PEX and Heating PEX-AL-PEX must be installed in accordance with all Watts installation procedures, including information provided in the Heating PEX and Heating PEX-AL-PEX installation manual and guidelines. 1. I nstall the Triple-Track Railways by securing them to the sub-grade prior to the tubing being installed. 2. C  ontinue installing Triple-Track Railways 4 ft (1.2 m) on center. 3. S  nap tubing into appropriate sized clip on Triple-Track Railways.

Description Railway, Triple-Track, 4' (1.2 m)

Qty 10

Order # 0955306

CAUTION

This Engineering Sheet is not intended to provide full installation instructions and safety information. In order to avoid property damage or injury, please refer to the complete installation manual and product safety information provided with the product.
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements, please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials without prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.

USA: No. Andover, MA Tel. (855) 699-2887 Fax: (978) 794-1848 radiant.watts.com Canada: Burlington, ONT. Tel. (905) 332-4090 Fax: (905) 332-7068 radiant.watts.com

ES-Triple-Track-Railways 1142

2011 Watts

You might also like