Chapter 1

The OSI Model and

the TCP/IP Protocol Suite
Objectives
Upon completion you will be able to:

• Understand the architecture of the OSI model

• Understand the layers of the OSI model and their functions
• Understand the architecture of the TCP/IP Protocol Suite
• Differentiate between the OSI model and the TCP/IP Suite
• Differentiate between the three types of Internet addresses

TCP/IP Protocol Suite 1

 2.1 The OSI Model
● Established in 1947, the International Standards Organization (ISO)
is a multinational body dedicated to worldwide agreement on
international standards.
● An ISO standard that covers all aspects of network communications
is the Open Systems Interconnection (OSI) model.
● It was first introduced in the late 1970s.
The topics discussed in this section include:

Layered Architecture
Peer-to-Peer Processes
Encapsulation

TCP/IP Protocol Suite 2

 Note:

ISO is the organization.

OSI is the model

TCP/IP Protocol Suite 3

 Figure 2.1 The OSI model

TCP/IP Protocol Suite 4

 Figure 2.2 OSI layers

TCP/IP Protocol Suite 5

 Figure 2.3 An exchange using the OSI model

TCP/IP Protocol Suite 6

 2.2 Layers in the OSI Model
The functions of each layer in the OSI model is briefly described.

The topics discussed in this section include:

Physical Layer
Data Link Layer
Network Layer
Transport Layer
Session Layer
Presentation Layer
Application Layer
Summary of Layers

TCP/IP Protocol Suite 7

 Figure 2.4 Physical layer

● Physical Characteristics of interfaces and media

● Representation of bits
● Data rate
● Synchronization of bits
● Line configuration
● Physical topology
● Transmission mode

TCP/IP Protocol Suite 8

 Note:

The physical layer is responsible

for the movement of individual bits
from one hop (node) to the next.

TCP/IP Protocol Suite 9

 Figure 2.5 Data link layer

● Framing
● Physical addressing
● Flow control
● Error control
● Access control

TCP/IP Protocol Suite 10

 Note:

The data link layer is responsible for

moving frames from one hop (node) to
the next.

TCP/IP Protocol Suite 11

 Figure 2.6 Hop-to-hop delivery

TCP/IP Protocol Suite 12

 Figure 2.7 Network layer

● Logical Addressing
● Routing

TCP/IP Protocol Suite 13

 Note:

The network layer is responsible for

the delivery of individual packets from
the source host to the destination host.

TCP/IP Protocol Suite 14

 Figure 2.8 Source-to-destination delivery

TCP/IP Protocol Suite 15

 Figure 2.9 Transport layer

● Service Point Addressing

● Segmentation & Reassembly
● Connection Control
● Flow control
● Error control

TCP/IP Protocol Suite 16

 Note:

The transport layer is responsible for

the delivery of a message from one
process to another.

TCP/IP Protocol Suite 17

 Figure 2.10 Reliable process-to-process delivery of a message

TCP/IP Protocol Suite 18

 Figure 2.11 Session layer

● Dialog Control
● Synchronization

TCP/IP Protocol Suite 19

 Note:

The session layer is responsible for

dialog control and synchronization.

TCP/IP Protocol Suite 20

 Figure 2.12 Presentation layer

● Translation
● Encryption
● Compression

TCP/IP Protocol Suite 21

 Note:

The presentation layer is responsible

for translation, compression and
encryption.

TCP/IP Protocol Suite 22

 Figure 2.13 Application layer

● Network Virtual Terminal

● File transfer, access & management
● Mail services
● Directory services

TCP/IP Protocol Suite 23

 Note:

The application layer is responsible

for providing services to the user.

TCP/IP Protocol Suite 24

 Figure 2.14 Summary of layers

TCP/IP Protocol Suite 25

 2.3 TCP/IP Protocol Suite
● The TCP/IP protocol suite is made of five layers: physical, data link,
network, transport, and application.
● The first four layers provide physical standards, network interface,
internetworking, and transport functions that correspond to the first
four layers of the OSI model.
● The three topmost layers in the OSI model, however, are represented
in TCP/IP by a single layer called the application layer.
The topics discussed in this section include:

Physical and Data Link Layers

Network Layer
Transport Layer
Application Layer

TCP/IP Protocol Suite 26

 Figure 2.15 TCP/IP and OSI model

TCP/IP Protocol Suite 27

 2.4 Addressing
Three different levels of addresses are used in an internet using the
TCP/IP protocols: physical (link) address, logical (IP) address, and
port address.

The topics discussed in this section include:

Physical Address
Logical Address
Port Address

TCP/IP Protocol Suite 28

 Figure 2.16 Addresses in TCP/IP

TCP/IP Protocol Suite 29

 Figure 2.17 Relationship of layers and addresses in TCP/IP

TCP/IP Protocol Suite 30

 Example 1

In Figure 2.18 a node with physical address 10 sends

a frame to a node with physical address 87. The two
nodes are connected by a link. At the data link level
this frame contains physical (link) addresses in the
header. These are the only addresses needed. The rest
of the header contains other information needed at
this level. The trailer usually contains extra bits
needed for error detection.

See Next Slide

TCP/IP Protocol Suite 31

 Figure 2.18 Physical addresses

TCP/IP Protocol Suite 32

 Example 2

As we will see in Chapter 3, most local area networks

use a 48-bit (6 bytes) physical address written as 12
hexadecimal digits, with every 2 bytes separated by a
colon as shown below:

07:01:02:01:2C:4B
A 6-byte (12 hexadecimal digits) physical address.

TCP/IP Protocol Suite 33

 Example 3

In Figure 2.19 we want to send data from a node with network

address A and physical address 10, located on one LAN, to a
node with a network address P and physical address 95, located
on another LAN. Because the two devices are located on
different networks, we cannot use link addresses only; the link
addresses have only local jurisdiction. What we need here are
universal addresses that can pass through the LAN
boundaries. The network (logical) addresses have this
characteristic.

See Next Slide

TCP/IP Protocol Suite 34

 Example 3 (Continued)

The packet at the network layer contains the logical addresses,

which remain the same from the original source to the final
destination (A and P, respectively, in the figure). They will not
change when we go from network to network. However, the
physical addresses will change as the packet moves from one
network to another. The boxes labeled routers are
internetworking devices, which we will discuss in Chapter 3.

See Next Slide

TCP/IP Protocol Suite 35

 Figure 2.19 IP addresses

TCP/IP Protocol Suite 36

 Example 4

As we will see in Chapter 4, an Internet address (in

IPv4) is 32 bits in length, normally written as four
decimal numbers, with each number representing 1
byte. The numbers are separated by a dot. Below is an
example of such an address.

132.24.75.9
An internet address in IPv4 in decimal numbers

TCP/IP Protocol Suite 37

 Example 5

Figure 2.20 shows an example of transport layer

communication. Data coming from the upperlayers
have port addresses j and k ( j is the address of the
sending process, and k is the address of the receiving
process). Since the data size is larger than the network
layer can handle, the data are split into two packets,
each packet retaining the service-point addresses ( j
and k). Then in the network layer, network addresses
(A and P) are added to each packet.

See Next Slide

TCP/IP Protocol Suite 38
 Example 5 (Continued)

The packets can travel on different paths and arrive at

the destination either in order or out of order. The two
packets are delivered to the destination transport
layer, which is responsible for removing the network
layer headers and combining the two pieces of data
for delivery to the upper layers.

See Next Slide

TCP/IP Protocol Suite 39

 Figure 2.20 Port addresses

TCP/IP Protocol Suite 40

 Example 6

As we will see in Chapters 11, 12, and 13, a port

address is a 16-bit address represented by one decimal
number as shown below.

753
A 16-bit port address represented as one single number.

TCP/IP Protocol Suite 41

 2.5 IP Versions
IP became the official protocol for the Internet in 1983. As the Internet
has evolved, so has IP. There have been six versions since its inception.
We look at the latter three versions here.

The topics discussed in this section include:

Version 4
Version 5
Version 6

TCP/IP Protocol Suite 42