CES Wrong Answer Summary

Download as pdf or txt
Download as pdf or txt
You are on page 1of 5

Wrong answer summary

Installation: Fleet Management Limited MDB CES version: CES 6.0.9


Name: Manoj Kumar Pandey Test date: 12.06.2023
User ID: 12041 Test type: STCW
Time used: 50
Nationality: India Department: Deck
Academy: Level: Management
Batch: Vessel type: Bulk carrier
Show only wrong answers with negative score: No
Questions not answered, not listed below: 0

Question asked (LmoVD2k5):


Non distress calls on 2182 kHz and VHF channel 16 should not exceed:
Selected answer (score 0):
Two minutes.
Correct answer:
One minute.

Question asked (9ZsmCkjo):


Code signals concerning requests and general information on medical matters normally consist of:
Selected answer (score 0):
Letter H plus two other letters.
Correct answer:
Letter M plus two other letters.

Question asked (ZpDRTxR4):


According to the International Labour Organisation, how often should lifting appliances and items of loose gear be thoroughly inspected by
a competent person?
Selected answer (score 0):
Every 5 years.
Correct answer:
Annually.

Question asked (PbQF5tAg):


What is the probable cause of an error in the position shown on a GPS receiver set into '2D' fixing?
Selected answer (score 0):
The limit set on the HDOP figure is too great
Correct answer:
Incorrect height of the antenna set into the receiver

Question asked (wWglWyqt):


A MMSI number consist of:
Selected answer (score 0):
10 digits
Correct answer:
9 digits

Page 1/5
Wrong answer summary

Question asked (AmI4TJic):


You wish to send a DSC-message because of a m.o.b. situation and assistance by other ships is required. You have to choose the
category:
Selected answer (score 0):
Urgency
Correct answer:
Distress

Question asked (MP5T0wG$):


The display of the DSC-controller on board is showing the following lines:
TX call:Selectiveto: 02114200
Category:RoutineUSB:telephony
DSC Tx 2189.5 kHzsave>send<

This DSC-message must be transmitted in the mode:


Selected answer (score 0):
H3E
Correct answer:
F1B

Question asked (EWVZI6EB):


In area A1 the function "Transmission and reception of signals for locating" is mainly based on:
Selected answer (score 0):
the use of SARSAT COSPAS Epirbs
Correct answer:
the use of SART transponders

Question asked (hrTQY31T):


On area A3 the function "Transmission and reception of signals for locating" is mainly based on:
Selected answer (score 0):
the use of MF DSC
Correct answer:
the use of SART transponders

Question asked (ezg5Jse4):


In area A1 the function "Reception of shore to ship distress alerts" is mainly based on:"
Selected answer (score 0):
The use of MF DSC
Correct answer:
The use of VHF DSC

Question asked (UaOjsZS7):


What is the required number of hours that a SART's battery must be able to operate the unit in the standby mode?
Selected answer (score 0):
Three (3) days
Correct answer:
Four (4) days

Page 2/5
Wrong answer summary

Question asked (63M9Uu9d):


When should a crew member joining a ship for the first time be given some training and instructions in the use of the ship's fire-fighting
appliances ?
Selected answer (score 0):
As soon as possible but not later than 24 hours after he joins the ship
Correct answer:
As soon as possible but not later than 2 weeks after he joins the ship

Question asked (IZPl0pzn):


The operating mode of a pyrotechnic signal depends essentially on:
Selected answer (score 0):
The fact that the user is on board a liferaft, a lifeboat or ship
Correct answer:
Instructions or diagrams printed on its casing by the manufacturer

Question asked (rp9AyEUC):


What does ISM stand for?
Selected answer (score 0):
International Safe Manning Certification
Correct answer:
The International Management Code for the Safe Operation of Ships and for Pollution Prevention

Question asked (6Ficcn0v):


What colour flare is used to signal a safe landing place for small boats ?
Selected answer (score 0):
Yellow
Correct answer:
Green

Question asked (O4M0IENQ):


Who is responsible for ensuring that your ship’s security plan meets the requirements of the ISPS Code?
Selected answer (score 0):
Recognized Security Organization
Correct answer:
Company Security Officer

Question asked (#g67p5AZ):


How should mild steel slabs be loaded in a bulk carrier?
Selected answer (score 0):
Interlocked across the entire cargo hold with the longitudinal axes fore and aft
Correct answer:
Interlocked across the entire cargo hold with the longitudinal axes athwartships

Page 3/5
Wrong answer summary

Question asked (HZXhYHOm):


What immediate action should be taken if a ship unexpectedly runs aground and stops?
Selected answer (score 0):
Sound the General Alarm
Correct answer:
Stop engine(s)

Question asked (T04Y$EvQ):


For security purposes, the IMDG Code should be read in conjunction with the:
Selected answer (score 0):
IMO NVIC 24 and 46 CFR 2.05.
Correct answer:
Chapter XI-2 of SOLAS and Part A of the ISPS Code.

Question asked (2rBzAw#6):


When conducting a risk assessment for a shipboard work activity, the two elements to be considered are:
Selected answer (score 0):
The available manpower and their experience in this type of work.
Correct answer:
The potential severity of harm and the likelihood that harm will occur.

Question asked (SN77N46l):


If W = Displacement, L = length, B = Breadth, D = depth of vessel, Cb = Block Coefficient, Cw = Coefficient of Waterplane, RD = Relative
Density, then:
Selected answer (score 0):
W = L x B x D x RD
Correct answer:
W = L x B x D x CB / RD

Question asked (hac4tItq):


The majority of convensions adopted under the auspices of IMO fall into which of the three main categories:
Selected answer (score 0):
Maritime Safety, STCW, Maritime Security
Correct answer:
Maritime Safety, Prevention of Marine pollution, Liability and compensation

Question asked (GBQukJSJ):


What does the IMSBC Code emphasise with reference to the exposure of personal to the dust created when carrying some bulk cargoes?
Selected answer (score 0):
The responsibility of the Master to ensure that staff are wearing the correct clothing
Correct answer:
A high standard of personal hygiene

Page 4/5
Wrong answer summary

Question asked (DGUylMUC):


A Bulk Vessel is to load a cargo of grain; pre loading calculations show that IMO stability criteria cannot be achieved; the vessel should do
which of the following?
Selected answer (score 0):
The vessel will be unable to load the cargo
Correct answer:
The grain surfaces in some or all of the cargo spaces must be secured

Page 5/5

You might also like