Scribd
Upload
76 views2 pages

Question Paper

Uploaded by

Dipayan Das
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
76 views2 pages

Question Paper

Uploaded by

Dipayan Das
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

NATIONAL INSTITUTE OF TECHNOLOGY SIKKIM

Ravangla Campus
Barfung Block, Ravangla Sub Division, South Sikkim-737139
End-Term Examination, December 2022
Programme: B. Tech. Year: 3rd (Three)
Department: Mechanical Engineering Semester: 5th (Five)
Subject: Metrology and Instrumentation Lab Subject Code: ME15204
Max. Time: 10 minutes Max. Marks: 5

Name: Roll no.

PART A
Answer all the questions (0.5 X 10 = 5)

1. Determine the height of slip gauges for an angle of 45° using a sine bar of 200 mm long.
a) 121 mm
b) 90 mm
c) 141.4 mm
d) 121 mm
2. Wear allowance is provided on?
a) GO gauge
b) NO GO gauge
c) Both GO and NO GO gauge
d) When both are combine in one gauge
3. Consider the surface roughness profile as shown in the figure and calculate centre line
average Ra (in µm).

a) 1.0
b) 2.0
c) 2.5
d) 5.0
4. Which of the following is NOT true for auto collimator?
a) Contact measurement
b) Use of small tilts
c) High sensitivity
d) Used to determine parallelism

Student’s signature: Invigilator’s signature:


5. Slip gauges are finished by ______________.
a) Grinding
b) Polishing
c) Lapping
d) Attraction

6. Vernier height gauge is used for _____________.


a) Measuring height of a work piece
b) Checking right angular surfaces
c) Scribing horizontal lines on work piece
d) Scribing vertical lines on work piece

7. Bore gauge is used for measuring _____________.


a) Depth of a hole
b) Thickness of hollow cylinder
c) Outside diameter of a shaft
d) Inside diameter of a hole

8. 14.65 mm diameter can be measured with help of __________.


a) Vernier Caliper
b) Micrometer
c) Steel rule
d) All of the above

9. What is the least count of vernier bevel protractor?


a) 10ʹ
b) 5ʹ
c) 10ʺ
d) 5ʺ

10. Consider the following statements for accuracy of an instrument:


1) The accuracy of the instrument may be specified in terms of limits of error.
2) The specification of a point accuracy gives any information about the general accuracy
of the instrument.
3) The best way to conceive the idea of accuracy is to specify it in terms of the true value
of the quantity being measured.
Which one of the above statements are correct?
a) 1 and 2 only
b) 1 and 3 only
c) 2 and 3 only
d) 1, 2 and 3

Student’s signature: Invigilator’s signature:

You might also like