Scribd
Upload
47 views1 page

Torsion Dynometer

This document provides operating instructions for a 0.01 N torsion dynamometer. It details the purpose, description, technical specifications, experimenting literature, and handling of the dynamometer. The dynamometer allows for measuring small forces with little friction and without displacement through force compensation via a torsion force and lever arms.

Uploaded by

muzahir.ali.baloch2021
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
47 views1 page

Torsion Dynometer

This document provides operating instructions for a 0.01 N torsion dynamometer. It details the purpose, description, technical specifications, experimenting literature, and handling of the dynamometer. The dynamometer allows for measuring small forces with little friction and without displacement through force compensation via a torsion force and lever arms.

Uploaded by

muzahir.ali.baloch2021
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

R

Torsion dynamometer 0.01 N 02416.00

Operating instructions

6
5
7

1 PURPOSE 4 TECHNICAL SPECIFICATIONS


The 0.01 N torsion dynamometer allows to measure small Measuring range 10 mN
forces with little friction and without displacement. scale division 0.1 mN
A force acting on lever arm 4 is compensated through the Response sensitivity 0.05 mN
torsion force of a metallic band (torque comparison). Preliminary force compensation
through zero shift approx. 10 mN
2 DESCRIPTION Maximum lever load 0.2 N
1 Zero setting knob
2 Zero indication for lever arms
3 Suspension system 5 EXPERIMENTING LITERATURE
4 Lever arm Versuchseinheiten Physik,
5 Protective tube for lever arms Das elektrische Feld 1 16100.01
6 Eddy current attenuation, shortens setting time University laboratory experiments 00067.72
7 Rod for holding with standard support material
8 Force indication knob

3 HANDLING
– Couple measurement object to the end of a lever arm
without that the force to be measured acts
– Set force indication knob 8 to zero
– Set lever arms to the middle of zero indication for lever
arms 2 by means of zero setting knob 1
– Let force to be measured act and compensate deflec-
tion by means of force indication knob 8 (that is, bring
the lever arm to the middle of the zero indication). Now
the size of the force to be measured is set on the scale.

During setup, make sure the eddy current attenuation disk


6 can move freely. Protective tubes 5 are pushed over the
lever arms when the instrument is stored.

PHYWE SYSTEME GMBH · Robert-Bosch-Breite 10 · D-37079 · Göttingen · Telefon (05 51) 6 04-0 · Telefax (05 51) 60 41 07

You might also like