Scribd
Upload
138 views4 pages

Data Communications and Networking 2 Midterm Lab Answer

The document describes a midterm exam for a networking course. It consists of 5 multiple choice questions about IPv6 addressing, router functions, load balancing, routing metrics, and flash memory. The exam was completed in 6 minutes and 56 seconds with a perfect score of 100%.

Uploaded by

Kenneth Maylos
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
138 views4 pages

Data Communications and Networking 2 Midterm Lab Answer

The document describes a midterm exam for a networking course. It consists of 5 multiple choice questions about IPv6 addressing, router functions, load balancing, routing metrics, and flash memory. The exam was completed in 6 minutes and 56 seconds with a perfect score of 100%.

Uploaded by

Kenneth Maylos
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

UGRD-IT6223 Data Communications and

Networking 2
1. Home
2. My courses
3. UGRD-IT6223-2313T
4. Midterm Examination
5. Midterm Lab Exam

Started on Wednesday, 15 November 2023, 7:39 PM


State Finished
Completed on Wednesday, 15 November 2023, 7:45 PM
Time taken 6 mins 56 secs
Grade 100.00 out of 100.00
Question 1
Correct
Mark 20.00 out of 20.00

Flag question
Question text
Which command is used to configure an IPv6 address on a router interface so that the router will
combine a manually specified network prefix with an automatically generated interface
identifier?
Select one:

a.
ipv6 address ipv6-address/prefix-length eui-64

b.
ipv6 address ipv6-address/prefix-length

c.
ipv6 address ipv6-address/prefix-length link-local

d.
ipv6 enable
Question 2
Correct
Mark 20.00 out of 20.00
Flag question
Question text
Which of the following are 2 primary functions of a router?
1. Packet switching
2. Microsegmentation
3. Domain name resolution
4. Path selection
5. Flow control
Select one:

a.
3&5

b.
1&2

c.
1&5

d.
2&4
Question 3
Correct
Mark 20.00 out of 20.00

Flag question
Question text
Which statement describe a characteristicof load balancing?
Select one:

a.
Load balancing allows a router to forward packets over multiple paths to the same destination
network.

b.
If multiple paths with different metrics to a destinations exist, the router cannot support load
balancing.
c.
Load balancing occurs when a router sends the same packet to different destination networks.

d.
Unequal cost load balancing is supported by RIP.
Question 4
Correct
Mark 20.00 out of 20.00

Flag question
Question text
Which statement is true regarding routing metrics?
Select one:

a.
All routing protocols use the same metrics.

b.
EIGRP uses bandwidth as its only metric.

c.
The larger metric generally represents the better path.

d.
Routers compare metrics to determine the best path.
Question 5
Correct
Mark 20.00 out of 20.00

Flag question
Question text
Which two features are characteristics of flash memory?
1. Flash receives a copy of the IOS from RAM when a device is powered on.
2. Flash provides nonvolatile storage.
3. The contents of flash may be overwritten.
4. Flash is a component in Cisco switches but not in Cisco routers.
5. The contents of flash may be lost during a power cycle.
Select one:

a.
4&5

b.
1&5

c.
1&2

d.
2&3

You might also like