Le Modem Radio le plus rapide

Le RIPEX est une plate-forme radio offrant

un service de transfert de données
sans-fil, disponible 24/7. Le RIPEX est
utilisé pour des applications critiques
telles que le SCADA, la télémétrie et les
infrastructures des réseaux d'énergie,
des réseaux d 'eau ou de l 'exploitation
pétrolières et de gaz.

Leader du marché
● 1,7Mbps, 256 QAM
● Routage Dynamique
● Radio et Cellulaire en un seul produit
● Aucune limite de couverture

Performance Fiabilité
● 160, 300, 400, 800, 900MHz ● Design industriel durci -40° à +70°C
● CPFSK, 256QAM ● Test unitaire en étuve
● Canaux de 6,25 à 300kHz ● MTBF supérieur à 100 ans
● 10W, Half et Full-Duplex ● Routes de backup

Sécurité
● IPsec, AES256, RADIUS
● Firewall, VLAN
● Firmware à signature digitale,
boot sécurisé

www.racom.eu
 RipEX2 RipEX2e RipEX
Max. Speed 1.7 Mb/s @ 256QAM 250 kb/s @ 64QAM 166 kb/s @ 16DEQAM
Speed @ 25 kHz 167 kb/s 125 kb/s 83 kb/s
Spécifications Techniques Channel spacing
Interfaces
6.25 – 300 kHz
4x ETH, 1x SFP, 1x COM, 1x USB
6.25 – 50 kHz
2x ETH, 1x COM, 1x USB
6.25 – 50 kHz
1x ETH, 2x COM, 1x USB
mPCIe Yes No No
Full duplex Yes No No

Radio parameters RipEX2 RipEX2e RipEX

135–154; 154–174; 215-240; 300–320; 320–340; 340–360;
Frequency bands 135–175; 285–335; 335–400; 400–470; 450–520; 803 – 897; 860 – 960 MHz
368–400; 400–432; 432–470; 470-512; 928–960 MHz
Channel spacing 6.25; 12.5; 25; 50; 100; 150; 200; 250; 300 kHz 6.25; 12.5; 25; 50 kHz 6.25; 12.5; 25; 50 kHz
Frequency stability +/- 0.5 ppm +/- 1.0 ppm
QAM: 256QAM, 64QAM, 16DEQAM, D8PSK, π/4DQPSK, DPSK QAM: 64QAM, 16DEQAM, D8PSK, π/4DQPSK, DPSK QAM: 16DEQAM, D8PSK, π/4DQPSK, DPSK
Modulations
FSK: 4CPFSK, 2CPFSK FSK: 4CPFSK, 2CPFSK FSK: 4CPFSK, 2CPFSK
FEC (Forward Error Correction) 2/3; 3/4; 5/6; Off 3/4; Off
Gross data rate up to 1.7 Mb/s up to 250 kb/s up to 167 kb/s
RF Output power 20-40 dBm PEP (0.1-10 W RMS), 1 dB step programmable 20-40 dBm PEP (0.1-10 W RMS), 9 levels programmable
Duty cycle Continuous
Rx to Tx Time < 0.7 ms @ 25 kHz; < 1 ms @ 12.5 kHz channel < 1.5 ms
- 97 dBm (256QAM; 12.5 kHz; BER 10-6; 2/3 FEC) - 101 dBm (64QAM; 12.5 kHz; BER 10-6; 2/3 FEC) - 99 dBm (16DEQAM; 12.5 kHz; BER 10-6; 3/4 FEC)
Sensitivity
-117 dBm (2CPFSK; 12.5 kHz BER 10-6; 3/4 FEC) -117 dBm (2CPFSK; 12.5 kHz BER 10-6; 3/4 FEC) -111 dBm (2CPFSK; 12.5 kHz BER 10-6; 3/4 FEC)

Electrical
Primary power 10 to 30 VDC, negative GND
Rx 8.3 W @ 24 V 4.8 W @ 24 V
Tx 12 – 40 W @ 24 V 13 – 38 W @ 24 V
Sleep mode 0.01 W 0.1 W

Interfaces
Ethernet 4x 10/100/1000 Base-T Auto MDI/MDIX 4x RJ45 2x 10/100/1000 Base-T Auto MDI/MDIX 2x RJ45 1x 10/100 Base-T Auto MDI/MDIX 1x RJ45
1x 10/100/1000 Base or T/1000Base-SX
SFP No No
or 1000Base-LX 1x SFP
1x RS232/RS485 SW configurable 1x DB9F 1x RS232/RS485 SW configurable 1x DB9F 1x RS232 1x DB9F
Serial 2x RS232 (mPCIe expansion board) 1x RJ45 600 b/s – 1 Mb/s 1x RS232/RS485 SW configurable 1x DB9F
600 b/s – 1 Mb/s 300 b/s – 115 kb/s
USB USB 3.0 / Host A USB 1.1 / Host A
2x TNC female @ 50 ohms 1x TNC female @ 50 ohms (Rx/Tx) or
Antenna 1x TNC female @ 50 ohms, Rx/Tx
SW configurable: 1x Rx/Tx or 1x Rx + 1x Tx 2x TNC (1x Rx + 1x Tx) - different HW model
1x HW alarm input, 1x HW alarm output, 1x Sleep input,
Inputs/Outputs 1x HW alarm input, 1x HW alarm output, 1x Sleep input 1x HW alarm input, 1x HW alarm output, 1x Sleep input
2x DI, 2x DO, 1x DiffDI (when mPCIe-COMS is not used)

Optional Expansions 1x mPCIe: Cellular module or 2x RS232 or GPS No GPS

Indication LEDs
5x tri-color status LEDs 7x tri-color status LEDs
LED panel
(SYS, AUX, Rx, Tx, COM) (Power, ETH, COM1, COM2, Rx, Tx, Status)
ETH 4x RJ45 (Link and Activity LEDs), 1× SFP (Status LED) 2x RJ45 (Link and Activity LEDs)
Environmental
IP Code (Ingress Protection) IP41, IP42, IP52 IP40, IP51
MTBF (Mean Time Between Failure) > 900 000 hours (> 100 years)
Operating temperature - 40 to +70 °C (- 40 to +158 °F)
Operating humidity 5 to 95% non-condensing
Mechanical
Casing Rugged die-cast aluminium
Dimensions 60 H x 185 W x 125 D mm (2.34 x 7.2 x 4.9 in) 50 H x 150 W x 118 D mm (1.97 x 5.9 x 4.65 in)
Weight 1.55 kg (3.4 lbs) 1.1 kg (2.4 lbs)
Mounting DIN rail, L-bracket, Flat-bracket, 19″ Rack chassis
Radio channel
Radio protocols Transparent @ Bridge; Flexible, Base driven @ Router
Routing (Radio channel included) Static, Dynamic Static, Backup routes
Multi master applications Yes
Report by exception Yes
Collision Avoidance Capability Yes
Remote to Remote communication Yes
Repeaters Store-and-forward; Every unit; Unlimited number
QoS 8 levels on all interfaces, Radio included
SCADA protocols
Serial DNP3, DF1, IEC101, Modbus RTU, PR2000, RDS, Siemens 3964(R), COMLI, SAIA S-bus, Mars-A, UNI, Async Link…
Ethernet Modbus TCP, IEC104, DNP3 TCP, Comli TCP…
Serial to IP convertors Modbus RTU / Modbus TCP, DNP3 / DNP3 TCP, Terminal server

Security
Management HTTPS (Web), SSH (CLI)
Role-based access control (RBAC) 4 levels (Guest, Tech, SecTech, Admin) 2 levels (Guest, Admin)
Encryption AES256 - CCM
VPN IPsec, GRE
VLAN IEEE 802.1Q (tagging), Q-in-Q for Transparent mode
AAA protocol RADIUS No
Firewall Layer 2 - MAC, Layer 3 - IP, Layer 4 - TCP/UDP
FW Digitally signed, Secure boot
HW tamper Case opening evidence No

Diagnostics
Radio link testing Ping with RSS, MSE (DQ)
Logs Status, Event log Status
Statistics Historical and differential statistics (Rx/Tx packets etc.) for all interfaces, for Radio channel in adition RSS, MSE (DQ), Repeats etc.
Monitoring Real time analysis of all interfaces (Radio, ETH 1-5 , COM 1-3, Cellular...)
NTP Client, Server
SNMP SNMPv1, SNMPv2c, SNMPv3, SNMP Trap / Inform alarms generation as per settings
SMS SMS alarms generation as per settings No No
Approvals CE (RED), FCC, … Ask for others

Les données techniques sont sujettes à modification sans notification préalable. Pour plus d'informations consultez le manuel utilisateur.

ver. 4.0