0% found this document useful (0 votes)
25 views5 pages

ElDev E1

Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
25 views5 pages

ElDev E1

Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Electronic Circuits Example 1

Elektronik Devreler
• Determine the following for the fixed-bias
Prof. Dr. Nizamettin AYDIN configuration shown in the figure.
[email protected] (a) IBQ and ICQ.
(b) VCEQ.
http://www.yildiz.edu.tr/~naydin
(c) VB and VC.
(d) VBC.
(e) Determine the
saturation
current ICsat

1 2

Solution Example 2
• Given the
following load line
and the defined Q-
point, determine the
required values of
VCC, RC, and RB for
a fixed-bias
configuration.

3 4

Solution 2 Example 3
• From the figure • For the following emitter bias network,
determine:
(a) IB.
(b) IC.
(c) VCE.
(d) VC.
(e) VE.
(f) VB.
(g) VBC.

5 6

1
Solution 3… …Solution 3

7 8

Example 4 Example 5
• Determine the saturation current for the • Determine the
network of Example 3. dc bias voltage
• Solution: VCE and the
current IC for the
following
voltage-divider
network
configuration.

9 10

Solution 5 Example 6
• Repeat the
exact analysis
of Example 5 if
β is reduced to
70, and
compare
solutions for
ICQ and VCEQ.

11 12

2
Solution 6 Example 7
• The results clearly
show the relative
• Determine the quiescent levels of ICQ and VCEQ
insensitivity of the for the following network.
circuit to the
change in β.
• Even though β is
drastically cut in
half, from 140 to
70, the levels of
ICQ and VCEQ are
essentially the
same

13 14

Solution 7 Example 8
• For the following network:
(a) Determine ICQ and VCEQ.
(b) Find VB, VC, VE, and VBC.

15 16

Solution 8 Example 9
• Determine VC and VB for the following network.

17 18

3
Solution 9 Example 10
The following emitter-
bias configuration has
the following
specifications:
ICQ =½Icsat ,
ICsat = 8 mA,
VCC = 28 V
VC = 18 V, and
β =110.
Determine RC, RE, and RB.

19 20

Solution 10 Example11
• Determine RB and RC for the following
transistor inverter if ICsat = 10 mA.

21 22

Solution 11… …Solution 11

23 24

4
Example 12 Solution 12
• Based on the readings
provided in the
following network,
determine whether the
network is operating
properly and, if not, the
probable cause.

25 26

Example 13 Solution 13…


• Determine
VCE for the
following
voltage-
divider bias
configuration.

27 28

…Solution 13

29

You might also like