0% found this document useful (0 votes)
11 views

Tutorial 6

This document discusses problems involving fluid flow through pipes and channels including calculating flow rates, pressure losses, and velocity profiles. It contains 6 problems related to topics like laminar and turbulent flow, venturimeters, pressure losses in pipes, and power calculations for fluid systems.

Uploaded by

Fardeen Razif
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
11 views

Tutorial 6

This document discusses problems involving fluid flow through pipes and channels including calculating flow rates, pressure losses, and velocity profiles. It contains 6 problems related to topics like laminar and turbulent flow, venturimeters, pressure losses in pipes, and power calculations for fluid systems.

Uploaded by

Fardeen Razif
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ME 3100: BASIC THERMAL ENGINEERING

Tutorial 6

1. In the laminar flow of a fluid in a circular pipe, the velocity profile is exactly a parabola.
The rate of discharge is then represented by the volume of a paraboloid. Prove that
for this case, the ratio of the maximum velocity to the average velocity is 2.

2. An oil of specific gravity 0.8 flows through a venturimeter. At the entry section 1,
diameter is 50 mm and at the throat is 30 mm. If the pressure differential between
the inlet and the throat is 0.1 m of mercury, determine the flow rate. You may neglect
viscous effect of oil. Assume the flow is steady.

3. A 45o reducing bend as shown in figure with upstream diameter of 0.6 m and
downstream diameter of 0.3 m has water flowing through it at a rate of 0.45 m 3/s
under a pressure of 1.45 bar. Neglecting losses in the bend, determine the force
exerted by water on the bend which is in horizontal plane.

4. A fluid flows through a 0.1 m diameter pipe at 20 oC. The average velocity is 0.102 m/s.
Determine if the flow is laminar or turbulent when the fluid is (a) air (density is 1.2
kg/m3, kinematic viscosity is 1.5 x 10-5 m2/s) and (b) water (density is 1000 kg/m3,
kinematic viscosity is 1x 10-6 m2/s). Justify your answer.

5. Find the head loss in a pipe which runs for 10 kms and has a pipe diameter of 2 cm.
The average velocity of flow is 3 m/s and kinematic viscosity of the fluid is 4x10-5 m2/s).

6. Air (density is 1.2 kg/m3, dynamic viscosity is 1.8 x 10-5 Pa-s) is forced at 25 m/s through
a 0.3 m square steel duct which is 148 m long. Calculate the power corresponding to
head loss, if f=0.015.

You might also like