Scribd
Upload
36 views4 pages

Log Nexeren

Uploaded by

José Dagdg
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
36 views4 pages

Log Nexeren

Uploaded by

José Dagdg
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 4

DIAM-BlagnacCTVPN58445A>show int desc

Interface Status Protocol Description


Gi0/0/0 up up WAN-uplink2CT
Gi0/0/1 down down downlink-to-LAN
Gi0 admin down down
DIAM-BlagnacCTVPN58445A>show int gi0/0/0
GigabitEthernet0/0/0 is up, line protocol is up
Hardware is ISR4321-2x1GE, address is 084f.a948.a880 (bia 084f.a948.a880)
Description: WAN-uplink2CT
Internet address is 10.0.200.6/30
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not supported
Full Duplex, 100Mbps, link type is force-up, media type is RJ45
output flow-control is on, input flow-control is on
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:07, output hang never
Last clearing of "show interface" counters never
Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
215 packets output, 27045 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
DIAM-BlagnacCTVPN58445A>
DIAM-BlagnacCTVPN58445A>show run
^
% Invalid input detected at '^' marker.

DIAM-BlagnacCTVPN58445A>do show run


^
% Invalid input detected at '^' marker.

DIAM-BlagnacCTVPN58445A>show run
DIAM-BlagnacCTVPN58445A>show run?
% Unrecognized command
DIAM-BlagnacCTVPN58445A>show ?
aaa Show AAA values
accounting Show accounting
adjacency Adjacent nodes
alg ALG information
ancp ANCP information
aps APS information
arp ARP table
auto Show Automation Template
backup Backup status
banner Display banner information
bfd BFD protocol info
bgp BGP information
bootvar Boot and related environment variable
bridge-domain Bridge-domain
call Show call
call-home Show command for call home
capability Capability Information
cca CCA information
cdapi CDAPI information
class-map Show CPL Class Map
clock Display the system clock
cns CNS agents

DIAM-BlagnacCTVPN58445A>en
Password:
Password:
DIAM-BlagnacCTVPN58445A#show run
Building configuration...

Current configuration : 1707 bytes


!
! Last configuration change at 13:49:10 UTC Tue May 7 2024
!
version 16.6
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
platform qfp utilization monitor load 80
no platform punt-keepalive disable-kernel-core
!
hostname DIAM-BlagnacCTVPN58445A
!
boot-start-marker
boot-end-marker
!
!
vrf definition Mgmt-intf
!
address-family ipv4
exit-address-family
!
address-family ipv6
exit-address-family
!
enable password 7 05280F1C22431F5B4A
!
no aaa new-model
!
!
!
!
!
!
!
!
!
!
!
subscriber templating
!
!
multilink bundle-name authenticated
!
!
!
!
!
!
license udi pid ISR4321/K9 sn FDO23280KEH
diagnostic bootup level minimal
spanning-tree extend system-id
!
!
!
username cisco123 privilege 15 password 7 070C285F4D065F2C39373F
!
redundancy
mode none
!
!
!
!
!
!
!
!
interface GigabitEthernet0/0/0
description WAN-uplink2CT
ip address 10.0.200.6 255.255.255.252
speed 100
no negotiation auto
!
interface GigabitEthernet0/0/1
description downlink-to-LAN
no ip address
negotiation auto
!
interface GigabitEthernet0
vrf forwarding Mgmt-intf
no ip address
shutdown
negotiation auto
!
router bgp 65130
bgp log-neighbor-changes
redistribute connected
neighbor 10.0.200.5 remote-as 4809
neighbor 10.0.200.5 description WAN-uplink2CT
!
ip forward-protocol nd
ip http server
ip http authentication local
ip http secure-server
ip tftp source-interface GigabitEthernet0
!
!
!
!
!
!
control-plane
!
!
line con 0
transport input none
stopbits 1
line aux 0
stopbits 1
line vty 0 4
exec-timeout 30 0
privilege level 15
login local
transport input all
!
wsma agent exec
!
wsma agent config
!
wsma agent filesys
!
wsma agent notify
!
!
end

DIAM-BlagnacCTVPN58445A#
DIAM-BlagnacCTVPN58445A#show bgp
BGP table version is 2, local router ID is 10.0.200.6
Status codes: s suppressed, d damped, h history, * valid, > best, i - internal,
r RIB-failure, S Stale, m multipath, b backup-path, f RT-Filter,
x best-external, a additional-path, c RIB-compressed,
t secondary path,
Origin codes: i - IGP, e - EGP, ? - incomplete
RPKI validation codes: V valid, I invalid, N Not found

Network Next Hop Metric LocPrf Weight Path


*> 10.0.200.4/30 0.0.0.0 0 32768 ?
DIAM-BlagnacCTVPN58445A#show bgp sum
BGP router identifier 10.0.200.6, local AS number 65130
BGP table version is 2, main routing table version 2
1 network entries using 248 bytes of memory
1 path entries using 136 bytes of memory
1/1 BGP path/bestpath attribute entries using 280 bytes of memory
0 BGP route-map cache entries using 0 bytes of memory
0 BGP filter-list cache entries using 0 bytes of memory
BGP using 664 total bytes of memory
BGP activity 1/0 prefixes, 1/0 paths, scan interval 60 secs

Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down


State/PfxRcd
10.0.200.5 4 4809 0 0 1 0 0 never Active
DIAM-BlagnacCTVPN58445A#

You might also like