Scribd Logo
Upload

Welcome to Scribd!

  • 7 views

    Machine Design 1 Assignment 2nd Sem S.Y 2023 24

    Uploaded by

    Mark David Moradas

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd

    Machine Design 1 Assignment 2nd Sem S.Y 2023 24

    Uploaded by

    Mark David Moradas
    7 views1 page

    Copyright

    © © All Rights Reserved

    Available Formats

    DOCX, PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd
    Download as docx, pdf, or txt
    7 views1 page

    Machine Design 1 Assignment 2nd Sem S.Y 2023 24

    Uploaded by

    Mark David Moradas

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd
    Download as docx, pdf, or txt
    of 1

    COLLEGE OF ENGINEERING

    Machine Design 1
    Assignment No. 1
    PROBLEMS:

    1. Compute the safe wall thickness of a 90 cm diameter steel tank.


    The tank is subjected to 8.5 MPa pressure and the steel material
    has yield stress of 230 MPa. The factor of safety to use is 3.5
    2. A cylinder having an internal diameter of 24 in and an external
    diameter of 38 in is subjected to an internal pressure of 14,000
    psi and an external pressure of 2,500 psi. Determine the hoop
    stress at the inner of the cylinder.
    3. A cylindrical tank with 12 inches inside diameter contains
    oxygen gas at 2,200 psi. Calculate the required wall thickness in
    (mm) under stress of 27,000 psi.
    4. Compute for the diameter (in inches) of a SAE 1030 steel shaft to
    transmit 24 hp at 125 rpm with torsional deflection below 0.08
    degree/foot length as required. Use G = 12,000,000 psi for steel.
    5. A 3.8 inches diameter short shaft carrying 2 pulleys close to the
    bearings transmits how much horsepower if the shaft makes 360
    rpm.
    6. Compute the speed of the gear mounted on 65.5 mm diameter
    shaft receiving power from a driving motor with 300 hp.
    7. A solid cylindrical shaft 48.4 cm long is used for a transmission of
    mechanical power at a rate of 44 kw running at 1780 rpm. The
    shearing stress is 8.23Mpa. Calculate the diameter.
    8. Find the torsional moment (in Newton-mm) developed when the
    shaft delivers 25 kw at 245 rpm.

    Prepared By:

    ENGR. ALDWIN G. FOROSUELO


    Instructor

    You might also like