Dome P2230l-Esr
Dome P2230l-Esr
Dome P2230l-Esr
International Standards
Organization Registered Firm;
ISO 9001 Quality System
Ø 3.80
(1.50)
20.91
(8.23)
CAMERA/OPTICS
Specification Value
Sensor Type 1/2.8-inch CMOS Sensor
Optical Zoom 30X
Digital Zoom 12X
Maximum Resolution 1920 x 1080
Lens f/1.6 ~ f/4.4, focal length 4.5 mm (wide) ~ 135 mm (tele)
Horizontal 59.8° (wide) ~ 2.34° (tele)
Angle of View Vertical 40.5° (wide) ~ 1.48° (tele)
Diagonal 67.8° (wide) ~ 2.77° (tele)
Aspect Ratio 16:9
Color (33 ms) 0.1 lux
Color (125 ms) 0.025 lux
Light Sensitivity Mono (33 ms) 0.05 lux
Mono (125 ms) 0.01 lux
Mono with IR 0.0 lux
Note: Sensitivity in lux for 90% reflectance, f/1.6 (wide angle),
45 dB gain at 30 IRE (30% of signal level)
Day/Night Capabilities Yes
Shutter Range 1/4 ~ 1/30,000 sec
Signal-to-Noise Ratio >50 dB
IR Cut Filter Yes
True Wide Dynamic Range Up to 120 dB Max; 100 dB per IEC62676
Iris Control Auto Iris with Manual Override
Backlight Compensation Yes
Automatic Gain Control Yes
Active Noise Filtering 3D Noise Filtering
Digital Image Stabilization (DIS) Yes
Scanning Progressive Scanning System
TECHNICAL SPECIFICATIONS
GENERAL MECHANICAL
Construction Aluminum Variable Speed 0.1° to 100°/sec (manual pan speed)
Cable Entry (Back Box) Preset Accuracy ±0.1°
Pendant Through 1.5-inch NPT pendant mount Pan Movement 360° continuous pan rotation
Weight (Approximate) Unit Shipping Vertical Tilt +15° to –90° degrees
Environmental Pendant 5.2 kg (11.5 lb) 6.2 kg (13.7 lb) Maximum Pan Speed Up to 300° per second
Effective Projected Area (EPA)* 63.5 square inches (without mount), Maximum Tilt Speed Up to 145° per second
109.8 square inches (with IWM Series mount) Manual Pan/Tilt Speeds
*0.8 drag coefficient assumed. Air temperature and wind velocity Pan 0.1° to 100°/sec manual operation
impact drag coefficient so if a more accurate EPA is required, then Tilt 0.1° to 50°/sec manual operation
the drag coefficient must be determined experimentally.
Preset Speeds
Clock Real time clock
Pan 300°/sec
IR Wavelength 850 nm
Tilt 145°/sec
IR Range 150 m
ELECTRICAL
ALARM Ports RJ-45 connector for 100Base-TX
Auto MDI/MDI-X
Unsupervised Detects open or closed alarm state
Autonegotiate/manual setting
Input Two alarms, 3.5 VDC maximum, 3.5 mA Cabling Type Cat5e or better for 100Base-TX
maximum
Input Voltage 21 to 32 VAC; 24 VAC nominal
Relay Output Two outputs, ±30 VDC maximum, 150 mA
38 to 57 VDC; 48 VDC nominal
maximum
Input Power
24 VAC 1 A (24 VA) maximum (without IR, PTZ, and
heater);
AUDIO 3.3 A (80 VA) maximum (with IR, PTZ, and
Input/Output Line level/external microphone input; 1Vp-p heater)
maximum signal level 48 VDC 0.46 A (22 W) maximum (without IR, PTZ, and
Streaming Embedded audio heater);
1.2 A (57 W) maximum (with IR, PTZ, and
heater)
OPERATING TEMPERATURE*
802.3bt (56 V) 0.37 A (20 W) maximum (without IR, PTZ, and
heater);
Temperature Environmental Pendant 1.1 A (61 W) maximum (with IR, PTZ, and
heater)
Maximum1 60°C (140°F)
Minimum1 –40°C (–40°F)
CERTIFICATIONS/RATINGS
Cold Start2 –40°C (–40°F)
• CE, Class A
Storage Temperature –40°C to 60°C (–40°F to 140°F) • FCC, Class A
• ICES-003, Class A
*
Assumes no wind chill factor. • UL/cUL Listed
1 • RCM
For outdoor applications.
2
• KC
Cold starts within 20 minutes at specified temperature. • ONVIF Profile S
• ONVIF Profile G
OPERATING HUMIDITY • ONVIF Profile Q
• ONVIF Profile T
Environmental Pendant 0 to 90% RH (condensing)
• IEC 62676 Part 5
• Environmental models meet Type 4X and IP66 standards when installed
properly
TECHNICAL SPECIFICATIONS
Pelco Pelco, the Pelco logo, and other trademarks associated with Pelco products referred
625 W. Alluvial, Fresno, California 93711 United States to in this publication are trademarks of Pelco, Inc. or its affiliates. ONVIF and the
ONVIF logo are trademarks of ONVIF Inc. All other product names and
USA & Canada Tel (800) 289-9100 Fax (800) 289-9150
services are the property of their respective companies.
International Tel +1 (559) 292-1981 Fax +1 (559) 348-1120 Product specifications and availability are subject to change without notice.
www.pelco.com www.pelco.com/community ©Copyright 2019, Pelco, Inc. All rights reserved.