Scribd
Upload
47 views2 pages

Xor Gate Experimant 5

Uploaded by

nemiacatamin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
47 views2 pages

Xor Gate Experimant 5

Uploaded by

nemiacatamin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

NAME: ___________________________________ SECTION :______________________

THE XOR GATE


Experiment No 4
I. OBJECTIVE
• To be able see the behavior of XOR gate base on the comparison of output.
• To be able to verify the function of XOR gate.
II.MATERIALS
• Breadboard • Connecting wire
• LED ( 6 pieces ) • Alligator clip
• Supply ( 6 V) • 7486 TTL IC

7486 PIN CONFIGURATION

III.PROCEDURE
1. Interconnect the XOR gate as shown below.
LED 1 LED 2 LED 3 LED 4 LED 5 LED 6

S1
S2

S3
S4
5.1KΩ 5.1KΩ

S5
5.1 KΩ

S6
5.1 KΩ
2. Switch on the power supply. Record the data inputs and outputs on table 1.

INPUTS OUTPUT
S1 S2 LED 1 LED 2 LED 3
0 0

3. What is the inputs ( S1/ S2 ) are required to produce a low logic level at the output ( LED 3 )?
___________________________________________________________________________

4. What is the inputs ( S1/ S2 ) are required to produce a high logic level at the output ( LED 3 )?
___________________________________________________________________________

5. The second set of gates is composed of XOR gates 2 to 4. Note that only the outputs ( LED 4 to LED 6)
are monitored. Fill up the table below to determine the circuit function.
INPUTS OUTPUTS
S3 S4 S5 S6 LED 4 LED 5 LED 6
0 0 0 0
0 0 0 1
0 0 1 0
0 0 1 1
0 1 0 0
0 1 0 1
0 1 1 0
0 1 1 1
1 0 0 0
1 0 0 1
1 0 1 0
1 0 1 1
1 1 0 0
1 1 0 1
1 1 1 0
1 1 1 1

6. What input signals ( S3 to S6 ) are required to produce a low logic level at e output ( LED5 )?
__________________________________________________________________
7. What input signal ( S3 to S6 ) are required to produce a high logic level signal at the output (LED 6)?
_______________________________________________________________________
8. What general rule can you formulate based on the results of step 5, 6 and 7?
_____________________________________________________________________________

You might also like