Campfire Blanket

Patterns
Coat With Hood
Cape
Poncho 1
Coat
Poncho 2
Simple Folded Blanket
Cloak
Poncho 3
Poncho 4

With thanks to Jason Spangler at http://www.santeeswapper.com/campfire_blankets.htm

2 Forest Drive, Sylvan Lake, Alberta, Canada T4S 1H8

Phone 403.864-4825 Fax 403.864-4830 e-patchesandcrests.com
 Australian Camp Blanket 1
COAT WITH HOOD
• Using a blanket 184cm by
142cm, cut out the pattern
shown on the diagram.
• Cut hood from the left over
section, joining at the centre
back.
• Gather neck section of the hood
to fit the neckline of the jacket.
Turn under 5cm edge and
blanket stich the front of the
hood.
• Stitch hood onto the jacket with
the right sides facing. Overlock.
• Make buttonholes where
marked on the front and stitch
buttons to corresponding
section on the inside of the
back.
• Curve edges as on diagram.
Turn under and blanket stitch all
edges in a contrasting
embroidery thread.

With thanks to Jason Spangler at http://www.santeeswapper.com/campfire_blankets.htm

2 Forest Drive, Sylvan Lake, Alberta, Canada T4S 1H8

Phone 403.864-4825 Fax 403.864-4830 e-patchesandcrests.com
 Australian Camp Blanket 2
CAPE
• Buy a blanket approx 170cm by
160cm
• Fold the blanket in half
widthwise and crosswise.
• Cut out a full circle 60cm in
radius, marking with pins first.
• Cut down a single fold at the
front.
• Cut out a small section for the
neckline, as on the diagram.
• Cut pieces from the leftovers to
measure 202cm by 22cm when
joined for use as a tie.
• Mark centre of the tie and pin it
at the centre back of the
neckline with the right sides
facing
• Stitch tie around the neck,
easing where necessary.
• Turn to wrong side and turn
under a 1cm edge and slip stitch
down leaving the tie open from
the neck edges.
• Blanket stitch all around the
cape and around the edges of
the tie.

With thanks to Jason Spangler at http://www.santeeswapper.com/campfire_blankets.htm

2 Forest Drive, Sylvan Lake, Alberta, Canada T4S 1H8

Phone 403.864-4825 Fax 403.864-4830 e-patchesandcrests.com
 Australian Camp Blanket 3
PONCHO
• Use a blanket approx 102cm
square
• Fold the blanket diagonally
and then in half again.
• Cut a small neck hole as on the
diagram and slit 10cm deep at
the front.
• Turn the edges of these under
and blanket stitch.
• Using contrasting wools which
tone with the blanket, make a
thick plait 80cm long. Knot the
ends.
• Make two loops with crochet
chain or thread covered with
buttonhole stitch at either side
of the front neck edge.
• Thread plaited tie through
loops and knot loosely.

With thanks to Jason Spangler at http://www.santeeswapper.com/campfire_blankets.htm

2 Forest Drive, Sylvan Lake, Alberta, Canada T4S 1H8

Phone 403.864-4825 Fax 403.864-4830 e-patchesandcrests.com
 Australian Camp Blanket 4
COAT
• Using a blanket approx
122cm by 180cm
• Fold the blanket in half
widthwise.
• Following the diagram,
cut down the centre
front, cut out neckline
and underarm.
• With right sides facing
and using 2cm seams,
stitch round underarm
edges and side seams.
• Overlock and clip seams.
• Turn to right side. Turn
under 5cm and stitch
round all edges with
blanket stitch.
• Cut four ties from the
section cut out of the
underarm, each approx
32cm long and 5cm
wide.
• Turn under and stitch
round edges of the ties.
• Stitch by hand onto
front.

With thanks to Jason Spangler at http://www.santeeswapper.com/campfire_blankets.htm

2 Forest Drive, Sylvan Lake, Alberta, Canada T4S 1H8

Phone 403.864-4825 Fax 403.864-4830 e-patchesandcrests.com
 PONCHO STYLE 2

* Fold the blanket in half

lengthwise.
* Make a slit along the fold either
side of the centre line big
enough to slip your head
through.
* A further slit is cut down from
the centre of the first cut
making a T shape.
* Oversee the edges with a bright
coloured wool.
* Fold back the collar points and
decorate.

With thanks to Jason Spangler at http://www.santeeswapper.com/campfire_blankets.htm

2 Forest Drive, Sylvan Lake, Alberta, Canada T4S 1H8

Phone 403.864-4825 Fax 403.864-4830 e-patchesandcrests.com
 SIMPLE FOLDED BLANKET

* Fold the blanket in half lengthwise with a cord

running inside the fold.
* Tie this around the waist and arrange the
blanket so that it sits neatly around you.
* The outside fold of the blanket is now carried up
over the shoulders and head.
* The picture should help clarify this

With thanks to Jason Spangler at http://www.santeeswapper.com/campfire_blankets.htm

2 Forest Drive, Sylvan Lake, Alberta, Canada T4S 1H8

Phone 403.864-4825 Fax 403.864-4830 e-patchesandcrests.com
 CLOAK STYLE

* Measure the blanket from

the shoulders to just above
the ground.
* Let the rest of it fall down
outside the blanket to
somewhere around the
waist or above (depending
on your height).
* Oversew the edges of the
blanket together.
* Attach two large
decorative buttons to
toggles to one side of the
front and two cord loops
to the other for fastening.

With thanks to Jason Spangler at http://www.santeeswapper.com/campfire_blankets.htm

2 Forest Drive, Sylvan Lake, Alberta, Canada T4S 1H8

Phone 403.864-4825 Fax 403.864-4830 e-patchesandcrests.com
 PONCHO STYLE 3

Materials
• old blanket or new fabric 90 cm by 120 cm
• drawstring (heavy skate lace, thick cord or
something else suitable)
• scissors
• thread
• pins
• sewing machine

Make Your Poncho

1. Make a square for the main body of the
poncho by folding the fabric diagonally and
cutting off the excess strip, as shown. Save
the strip for the poncho hood.
2. Cut a neck opening about 27 cm wide. Be
careful not to make the opening too big.
3. From the strip of fabric, cut a piece large
enough to form a hood (about 60 cm by 30
cm). Fold it in half. The fold forms the top
of the hood.
4. Sew one side of the hood to form the back
seam.
5. Sew a casing around the front edge of the
hood, through which a drawstring can be
run.
6. Sew the bottom edge of the hood to the
neck opening, being careful not to sew the
casing shut.
7. If you wish, finish the edges of your poncho
with blanket stitch, a fringe, or hem.
8. With leftover fabric you can add a pocket or
two.

Reprinted with permission from Girl Guides of Canada

2 Forest Drive, Sylvan Lake, Alberta, Canada T4S 1H8

Phone 403.864-4825 Fax 403.864-4830 e-patchesandcrests.com
 PONCHO STYLE 4
Materials 62”

• 62 inches polar fleece

(piece of fabric should be 62’ x 60”)
• scissors
• thread
• pins Hood goes here
• sewing machine
Pocket 6”
Centre
Make Your Poncho Front Placed
Here 6”
of fabric Back 60”
1. Cut off a strip of material 14” wide from one long
side of the fabric. This will be used to make the 2”
pocket and hood.
2. Make seams 5/8” wide, unless otherwise specified.
3. HOOD:
a. Cut a 30” x 14” piece from the piece created in
step 1.
b. Fold hood in half, right sides together and sew
along one long unfinished edge. Trim seam.
14” Bed
c. Turn other unfinished edge back 1/2” and Buddie Pocket Hood
stitch down.
d. Stay stitch lower edge of hood. 30”
20”
4. PONCHO:
a. Fold blanket in half widthwise.
b. Locate centre of this fold. 5/8” seams
c. Measure 2” down from the centre of the fold. Turn under unfinished edges 1/2” and stitch
d. At this point, and through one thickness of the
blanket only, cut a slit 6” on either side of that
point. (The slit ends up being 12” wide.)
e. Fit the hood into slit in poncho, right sides d. Turn top, sides, and bottom edges of pocket under
together, and pin. Be sure to leave the opening 1/2” and pin to front of poncho. (Try on the poncho
at the front! The short side is the front. and ensure the pocket is at a comfortable height.)
f. Ease in fullness, being careful not to pull apart e. Stitch onto poncho. NOTE: do NOT stitch slanted
slit. sides; they are the openings to the pocket.
g. Stitch, then reinforce seam. The remaining pieces of fabric can be used to make a
h. Top stitch seam to make hood more secure. “Bed-time buddy” like the pew or handkerchief dolls of old.
5. POCKET: a. Using a square of fabric, turn down about 1/3 of the
If you want to sew crests onto the pocket, do so fabric. This will be the top.
before you attach it to the poncho. b. Make hands from the right and left hand top corners
a. Cut pocket out of piece left over from making using small elastic bands.
the hood. (20” x 14” at bottom and 10” on top c. Take a round fluff of fiberfill, or a couple of cotton
cutting slant for opening—see diagram) balls, and place beneath the fold in the centre for her
b. Turn under 1/2” of the slanted sides and zigzag head. Secure with another elastic band.
to secure. d. The leftover triangle can be used to make her a head
c. If desired, use contrasting yarn and blanket scarf. You can sew a face on your bed-time buddy and
stitch along these two sides. take her to camp with you.

With thanks to St. Albert, Alberta Girl Guides

2 Forest Drive, Sylvan Lake, Alberta, Canada T4S 1H8

Phone 403.864-4825 Fax 403.864-4830 e-patchesandcrests.com