Scribd
Upload
26 views3 pages

06-Inv Noninv Amp

Uploaded by

comp23gaurav.singh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
26 views3 pages

06-Inv Noninv Amp

Uploaded by

comp23gaurav.singh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Experiment No.

6
INVERTING AND NON-INVERTING AMPLIFIER USING OPAMP

AIM

To study the following op-amp circuits

1. Inverting amplifier
2. Non-inverting amplifier

DESIGN

1. Design for inverting amplifier

The expression for gain is A =−(Rf / R1 )

Let amplifier to be designed with a gain of (-10), select input resistance R1=10kΩ
Feedback resistance, Rf = –(ACL × R1 )
= –(–10 ×10×103 ) = 100 kΩ
2. Design for non- inverting amplifier

The expression for gain is A =(1+ Rf / R1 )

Let amplifier to be designed with a gain 11 and select R1 = 10kΩ

Feedback resistance, Rf = ( ACL –1)R1


= (11 –1) ×10× 103 = 100 kΩ

Rf 100 k
Vi

+15V
R1 10 k
Vi - 7 t
2
6
LM 741 Vo
+ 4
3 Vo
10 k -15V

Fig 1. Circuit diagram of inverting amplifier Fig 2. Input and output waveforms of inverting
amplifier

1
Fig 3. Circuit diagram of non-inverting amplifier Fig 4. Input and output waveforms of
non-inverting amplifier

PROCEDURE

1. Inverting Amplifier
Set up the circuit as shown in Fig 1. The circuit gives a closed loop gain A =−(Rf / R1 ).
This gain is very small compared to the open loop gain of the op-amp. Test the circuit by
applying the input signal of suitable amplitude (say 1V peak to peak) from a function
generator. Observe the output waveform on the CRO and determine actual gain.

2. Non-inverting Amplifier:
The circuit of a non-inverting amplifier is shown in Fig 3. Its closed loop gain is
A =(1+ Rf / R1 ) .
The circuit is tested by applying the input signal of suitable amplitude

(say 1V peak to peak) from a function generator. Observe the output waveform on the
CRO and determine actual gain.

OBSERVATIONS

Inverting Amplifier
Input Frequency Input voltage (p-p) Output voltage (p-p) Gain
f Vi Vo V
ACL = o
kHz V
i

2
Non-inverting Amplifier
Input Frequency Input voltage (p-p) Output voltage (p-p) Gain
f Vi Vo V
ACL = o
kHz V V V
i

RESULT

The basic op-amp circuits of inverting & non-inverting amplifiers were designed set up
and output waveforms were obtained in a CRO. The gain obtained are

Inverting amplifier:

Gain = ………….

Non-inverting amplifier:

Gain = ………….

You might also like