WLSA SPEMOS

COMPONENTS AND CALIBRATION

1 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen

 SPEMOS - Speed monitoring system

Components
C1 Power supply card
C2 NDE-measuring converter with two relay
C3 Relay I
C4 NTC-measuring converter
C5 Relay II
C1 C2 C3 C4 C5

2 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen

 SPEMOS - Connections

Connections
Output ground: GND
Supply 18-40 VDC: +pin1, -pin2
DE speed sensor A: +pin7, ground pin8, signal pin9, shield pin14
DE speed sensor B: +pin10, ground pin11, signal pin12, shield pin14
DE speed meter: +pin18, ground pin19, shield pin 20
TC speed sensor B: signal pin22, ground pin24, shield pin21
TC speed meter A: +pin25, ground pin19, shield pin 20
TC speed sensor A: signal pin30, ground pin31, shield pin21
TC speed meter B: +pin35, ground pin19, shield pin 20
Output voltage: -pin43, +pin46

3 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen

 Speed meters and sensors

Speed meters
DE speed meter
TC speed meter A
TC speed meter B

Speed sensors
DE speed sensor A
DE speed sensor B
TC speed sensor A
TC speed sensor B

4 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen

 C1 Power supply card

Components
F1: T 1.6 A fuse
D13: Supply voltage 18-40 VDC indication
R29: Output voltage +12 V adjust
R21: Output voltage -12 V adjust

Calibration
Adjust R29 to get +12,0 V from pin46.
Adjust R21 to get -12,0 V from pin43.

5 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen

 C2 NDE-measuring converter with two relay
Components
P1: Output f/U adjust
D1: DE speed sensor A pulse indication
D2: DE speed sensor B pulse indication
TP4: Internal ground
TP3: Fuel limiter test point
TP2: By linking TP1 and TP2 full
TP1: RPM value should be achieved
D3: 0–speed indication
D4: Tacho/power fail indication
D5: Fuel limiter indication
P2: Fuel limiter adjust
P3: On-delay 8 s adjust
P4: Off-delay 2 s adjust
Calibration
Connect frequency generator ground to pin8 and signal to pin9 and pin12.
Set frequency “Speed meter maximum” Hz.
Adjust P1 to get +10,0 V from pin18.
Adjust P2 to get “Fuel limiter control” V from TP3.
Set frequency to “Fuel limiter control” Hz to lit D5.
6 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen
 C3 Relay I and C5 Relay II

Components
D1: Engine run indication
P601: Engine run adjust
TP1: Engine run test point
D2: Voltage regulator connection indication
P602: Voltage regulator connection adjust
TP2: Voltage regulator connection test point
D3: Over speed indication
P603: Over speed adjust
TP3: Over speed test point
Calibration
Connect frequency generator ground to pin8 and signal to pin9 and pin12.
Adjust P601 to get “Engine run” V from TP1.
Set frequency to “Engine run” Hz to lit D1.
Adjust P602 to get “Voltage regulator connection” V from TP2.
Set frequency to “Voltage regulator connection” Hz to lit D2.
Adjust P603 to get “Over speed” V from TP3.
Set frequency to “Over speed” Hz to lit D3.
7 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen
 C4 NTC-measuring converter

Components
P701: Turbocharger A adjust
P711: Turbocharger B adjust
TP1: Turbocharger A speed 0-3000 Hz
TP2: Turbocharger A speed 0-10 VDC
TP3: Turbocharger B speed 0-3000 Hz
TP4: Turbocharger B speed 0-10 VDC

Calibration
Connect frequency generator ground to pin31 and signal to pin30 and pin22.
Set frequency to “Speed meter maximum” Hz.
Adjust P701 to get +10,0 V from TP2 and pin25.
Adjust P711 to get +10,0 V from TP4 and pin35.

8 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen

 W46 – 500 rpm 50 Hz
Engine Turbocharger
f(HZ) rpm U(V) f(HZ) rpm U(V)
0 0 0 0 0 0
10.7 20 0.31 67 2000 0.67
42.7 80 1.23 133 4000 1.33
Engine run 64.0 120 1.85 200 6000 2.00
106.7 200 3.08 267 8000 2.67
133.3 250 3.85 333 10000 3.33
Voltage regulator connection 186.7 350 5.38 400 12000 4.00
Fuel limiter control 213.3 400 6.15 467 14000 4.67
226.7 425 6.54 533 16000 5.33
240.0 450 6.92 600 18000 6.00
Nominal speed 266.7 500 7.69 667 20000 6.67
280.0 525 8.08 733 22000 7.33
293.3 550 8.46 800 24000 8.00
Over speed 306.7 575 8.85 867 26000 8.67
320.0 600 9.23 933 28000 9.33
Speed meter maximum 346.7 650 10.00 1000 30000 10.00

9 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen

 W46 – 514 rpm 60 Hz
Engine Turbocharger
f(HZ) rpm U(V) f(HZ) rpm U(V)
0 0 0 0 0 0
10.7 20 0.31 67 2000 0.67
42.7 80 1.23 133 4000 1.33
Engine run 65.8 123 1.90 200 6000 2.00
106.7 200 3.08 267 8000 2.67
133.3 250 3.85 333 10000 3.33
Voltage regulator connection 191.9 360 5.54 400 12000 4.00
Fuel limiter control 220.8 414 6.37 467 14000 4.67
226.7 425 6.54 533 16000 5.33
240.0 450 6.92 600 18000 6.00
Nominal speed 274.1 514 7.91 667 20000 6.67
280.0 525 8.08 733 22000 7.33
306.7 575 8.85 800 24000 8.00
Over speed 315.3 591 9.09 867 26000 8.67
320.0 600 9.23 933 28000 9.33
Speed meter maximum 346.7 650 10.00 1000 30000 10.00

10 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen

 W32 – 720 rpm 60 Hz
Engine Turbocharger
f(HZ) rpm U(V) f(HZ) rpm U(V)
0 0 0 0 0 0
32.0 80 0.80 200 2000 0.67
48.0 120 1.20 400 4000 1.33
60.0 150 1.50 600 6000 2.00
80.0 200 2.00 800 8000 2.67
Engine run 115.2 288 2.88 1000 10000 3.33
160.0 400 4.00 1200 12000 4.00
200.0 500 5.00 1400 14000 4.67
Voltage regulator connection 207.4 518 5.18 1600 16000 5.33
Fuel limiter control 249.6 620 6.20 1800 18000 6.00
Nominal speed 288.0 720 7.20 2000 20000 6.67
310.0 775 7.75 2200 22000 7.33
Over speed 318.7 797 7.97 2400 24000 8.00
360.0 900 9.00 2600 26000 8.67
380.0 950 9.50 2800 28000 9.33
Speed meter maximum 400.0 1000 10.00 3000 30000 10.00

11 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen

 W32 – 750 rpm 50 Hz
Engine Turbocharger
f(HZ) rpm U(V) f(HZ) rpm U(V)
0 0 0 0 0 0
32.0 80 0.80 200 2000 0.67
48.0 120 1.20 400 4000 1.33
60.0 150 1.50 600 6000 2.00
80.0 200 2.00 800 8000 2.67
Engine run 120.0 300 3.00 1000 10000 3.33
160.0 400 4.00 1200 12000 4.00
200.0 500 5.00 1400 14000 4.67
Voltage regulator connection 216.0 540 5.40 1600 16000 5.33
Fuel limiter control 260.0 650 6.50 1800 18000 6.00
Nominal speed 300.0 750 7.50 2000 20000 6.67
310.0 775 7.75 2200 22000 7.33
Over speed 332.0 830 8.30 2400 24000 8.00
360.0 900 9.00 2600 26000 8.67
380.0 950 9.50 2800 28000 9.33
Speed meter maximum 400.0 1000 10.00 3000 30000 10.00

12 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen

 W20 – 900 rpm 60 Hz
Engine Turbocharger
f(HZ) rpm U(V) f(HZ) rpm U(V)
0 0 0 0 0 0
20.0 50 0.33 400 4000 0.67
40.0 100 0.67 800 8000 1.33
80.0 200 1.33 1200 12000 2.00
120.0 300 2.00 1600 16000 2.67
Engine run 144.0 360 2.40 2000 20000 3.33
200.0 500 3.33 2400 24000 4.00
240.0 600 4.00 2800 28000 4.67
Voltage regulator connection 259.2 648 4.32 3200 32000 5.33
Fuel limiter control 314.9 800 5.33 3600 36000 6.00
Nominal speed 360.0 900 6.00 4000 40000 6.67
420.0 1050 7.00 4400 44000 7.33
Over speed 396.0 990 6.60 4800 48000 8.00
500.0 1250 8.33 5200 52000 8.67
560.0 1400 9.33 5600 56000 9.33
Speed meter maximum 600.0 1500 10.00 6000 60000 10.00

13 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen

 W20 – 1000 rpm 50 Hz
Engine Turbocharger
f(HZ) rpm U(V) f(HZ) rpm U(V)
0 0 0 0 0 0
20.0 50 0.33 400 4000 0.67
40.0 100 0.67 800 8000 1.33
80.0 200 1.33 1200 12000 2.00
120.0 300 2.00 1600 16000 2.67
Engine run 160.0 400 2.67 2000 20000 3.33
200.0 500 3.33 2400 24000 4.00
240.0 600 4.00 2800 28000 4.67
Voltage regulator connection 288.0 720 4.80 3200 32000 5.33
Fuel limiter control 328.0 820 5.47 3600 36000 6.00
Nominal speed 400.0 1000 6.67 4000 40000 6.67
420.0 1050 7.00 4400 44000 7.33
Over speed 440.0 1100 7.33 4800 48000 8.00
500.0 1250 8.33 5200 52000 8.67
560.0 1400 9.33 5600 56000 9.33
Speed meter maximum 600.0 1500 10.00 6000 60000 10.00

14 © Wärtsilä 15 May 2008 WLSA Spemos / Janne Räsänen