Scribd
Upload
13 views2 pages

Design Engineering Report Guidelines

The document provides guidelines for a design engineering report including paper size and margins, required contents and their order, page numbering format, font styles for headings and text, spacing and alignment rules, and submission requirements.

Uploaded by

pvora220
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
13 views2 pages

Design Engineering Report Guidelines

The document provides guidelines for a design engineering report including paper size and margins, required contents and their order, page numbering format, font styles for headings and text, spacing and alignment rules, and submission requirements.

Uploaded by

pvora220
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Design Engineering Report Guidelines

PAPER: Use A4 (210mm X 297mm) Paper.


MARGINS: Margins for pages including the regular text should be as below:
Left : 1.25 Inches
Right : 1.0 Inch
Top : 1.0 Inch
Bottom : 1.0 Inch

CONTENTS: Following should be the order of contents for the report. This
order should be strictly maintained.
I. Cover Page
II. College Certificate
III. GTU Completion Certificate
IV. Acknowledgement
V. Abstract
VI. Table of Contents (Format given at the end)
VII. Chapters 1 to n

NUMBERING
✔ All pages in the report except the cover pages and certificates must be numbered.
✔ All the page numbers should be located at the BOTTOM CENTER of the page. ✔
The page numbering starting from Acknowledgement up to the beginning of the
chapters should be numbered in small roman letters, i.e. i, ii, …
✔ The page numbering starting from the beginning of Chapter 1 up to the end of the
report, should be numbered in Arabic numerals, i.e. 1,2, 3,….

Font :
Chapter Headings : Times New Roman 16pts, bold print all capitals Section
Headings : Times New Roman 14 pts, bold print all capitals Subsection Headings
: Times New Roman 12 pts, bold print leading capitals (only first letter in each
word should be capital
Regular Text : Times New Roman 12 pts, normal prints
Special Text : Times New Roman Italics 12 pts (for foot notes, symbols,
quotes, Mathematical notations….)

SPACING/ALIGNMENT
Use 1.5 spacing between lines of regular text

Use double spacing between:


1. Paragraphs
2. Chapter title and section Heading
3. Section heading and paragraphs
4. Table Title and Table
5. Figure Title and Figure

Use single spacing between:


1. text corresponding to bullets, listing and quotes in the main body of text
All paragraphs in the report are to be fully justified from the first line to the last line
and should start from left without any hyphenation/indent. Text corresponding to
bullets, listings and quotes in the main body of text should be indented.

NUMBER OF COPIES:
The student/group must submit 2 copies (spiral binding).

At the time of Submission following things must bring with


you: 1. Report(2 copies)
2. All canvases
3. Working Prototype model
4. Log book ( duly signed by internal guide)
5. Continuous Assessment card
6. Power point presentation (contents as per report)

You might also like