Scribd
Upload
20 views2 pages

Inspection

The document provides inspection procedures for a manual transmission switch, including measuring resistance values of different switch conditions and checking illumination of the switch assembly.

Uploaded by

Edson CR
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
20 views2 pages

Inspection

The document provides inspection procedures for a manual transmission switch, including measuring resistance values of different switch conditions and checking illumination of the switch assembly.

Uploaded by

Edson CR
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Print-Toyota Service Information 11/3/17, 7'41 pm

Print Exit

RC60F / RC61F MANUAL TRANSMISSION / TRANSAXLE INTELLIGENT MANUAL TRANSMISSION


SWITCH INSPECTION

PROCEDURE

1.INSPECT COMBINATION SWITCH ASSEMBLY (INTELLIGENT MANUAL 84970


TRANSMISSION SWITCH)

a.

Component without harness connected


*a
(Combination Switch Assembly)

Measure the resistance according to the value(s) in the table below.


Standard Resistance:
Tester Switch Specified
Connection Condition Condition
iMT switch
6 (S) - 2 (E) pushed and Below 1 Ω
hold
iMT switch not 10 kΩ or
6 (S) - 2 (E)
pushed higher
ECO mode
4 (ECU) - 2 (E) switch pushed Below 1 Ω
and hold
ECO mode
10 kΩ or
4 (ECU) - 2 (E) switch not
higher
pushed
POWER mode
3 (PWR) - 2
switch pushed Below 1 Ω
(E)
and hold
POWER mode
3 (PWR) - 2 10 kΩ or
switch not
(E) higher
pushed

If the result is not as specified, replace the combination switch assembly.

https://toyotamanuals.com.au/docs/hilux-service-repair-manual-j…manual/repair/contents/RM100000000LZ8S.html?PUB_TYPE=RM&MODE=1 Page 1 of 2
Print-Toyota Service Information 11/3/17, 7'41 pm

b.

Component without harness connected


*a
(Combination Switch Assembly)

Apply battery voltage between the terminals of the switch, and check the illumination condition of the
combination switch assembly.
Standard:
Measurement
Specified Condition
Condition
Battery positive (+) →
5 (ILL+) Battery Illuminates
negative (-) → 1 (ILL-)

If the result is not as specified, replace the combination switch assembly.

© 2012 TOYOTA MOTOR CORPORATION. All Rights Reserved.

https://toyotamanuals.com.au/docs/hilux-service-repair-manual-…manual/repair/contents/RM100000000LZ8S.html?PUB_TYPE=RM&MODE=1 Page 2 of 2

You might also like