Hardware Installation The RJ11 port of this Modem Router can only connect to ADSL Filter.

The RJ11 port of this Modem Router can only connect to ADSL Filter. Please follow steps in below diagram in correct order.

Quick Installation Guide PC

Wireless N ADSL2+ Modem Router Ports and Buttons Description

DC IN This socket is used to connect the power adapter.

POWER This button is used to power on or off the ADSL Router.

Telephone Cable
Suitable for: ND150,ND300
ADSL This RJ11 ADSL port is used to connect to the ISP.

1 LAN/WAN This port is used to connect the router to the local PC/ Internet.

2/3/4 LAN These ports are used to connect the router to local PC.

ADSL Splitter Press the button for more than 5 seconds, the router will restore factory settings.
WPS/RST For less than 5 seconds, the router will establish Wi-Fi protected settings(WPS)
automatically.

WiFi This button is used to power on/off the WiFi signal.

Power Adapter

NOTE:
1. Please disconnect the power adapter and all cables during thunderstorm weather;
Telephone Telephone 2. Keep away from heat source and keep well ventilated;
Cable Cable
3. Please pay attention to the waterproofing and moisture-proof when storing,
transporting and running.
V.14.10 4. The power supply must reach the rated current and power.
Network
2015 Cable 5. Put the router in flat places.
Information in this document is subject to change without prior notice.

Set Up PC
For Windows 2000 or Windows XP Operating System, please comply with following steps to set up. For Windows Vista or Windows 7 Operating System, please comply with following steps to set up.

Right-click “My Network Right-click “Local Area Double-click “Internet Protocol Choose “Obtain an IP address Click “Start— Control Panel— Network Double-click “Internet Protocol Choose “Obtain an IP address automatically”
Places”, click “Properties” Connection”, click “Properties” (TCP/IP)” automatically” and “Obtain DNS and Internet— Network Connection”, Version 4 (TCP/IPv4)” and “Obtain DNS server address automatically”,
server address automatically”, right-click “Local Area Connection”, click “OK”; go back to previous interface and
click “OK”; go back to previous and choose “Properties”. click “OK”
interface and click “OK”

Set Up Router Wireless Network Connection

Please set up the router following below steps.

Run the Web browser. 6 Setup the wireless parameters, then click APPLY to save your settings.

Right-click “My Network

Places”, click “Properties”
Type http://192.168.1.1 in the web browser, then press Enter. Input the encrytion key and click “Connect”

Confirm the wireless network SSID name,

choose one that you would like to connect,
then click “Connect”
7 Now, you have finished Easy Setup, click CLOSE.

Input the Username and Password, then click Login button

(The default Username and Password is admin).

Right-click “Wireless Network

Connection”, and click “View
Available Wireless Networks”
Have connected wireless network, you can access
NOTE: Internet through wireless mode.
After you set the Pre-Shared Key, please remember your SSID and
the Pre-Shared Key to connect with your wireless LAN.

Choose Easy Setup. Select the language according to your country

and click NEXT (The default language is English).
5 FAQ
How to reset the router to default factory settings?

1.When the router is powered on, press the WPS/RST button for about 10s.

2.The router’s CPU LED indicator keeps flashing, which means you have
reset your router to default settings successfully.

Fill in the related content based on the information provided

5 by your ISP, click Next.
How to find the IP address and user name & password
on the device?
On the rear panel of the Router, there is IP address, User name and
password printed on the sticker. See below:

For more information, please go to www.totolink.net

Downloaded from www.Manualslib.com manuals search engine