Scribd
Upload
17 views6 pages

Process Modeling and Simulation Usman

Uploaded by

ar77951234
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
17 views6 pages

Process Modeling and Simulation Usman

Uploaded by

ar77951234
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 6

Process Modeling and Simulation

Name: Zohaib Akram

Registration No: 2020-CH-31

Session 2020-2024

Assigned By: Engr. Ali Sarosh

Topic: Simulate heat


exchanger

Department: Chemical Engineering

1
Problem Statement:

Specifications Hot Stream Cold Stream


Shell Side Tube Side

Stream Ethanol Water


Flow Rate ( kg/h) 100 1000
Inlet Temperature (oC) 150 25
Pressure Drop (bar) 0.1 0.2
Outlet Temperature (oC) ? 40
Inlet Pressure (bar) 3 2.5

Finds the outlet temperature of hot stream LMTD, Ft factor and heat duty.

2
Solution:
 First of all add components water and ethanol.

 Then add a fluid package NTRL.

3
 Then added a heat exchanger and place the hot stream to shell side and cold stream in
tube side.

 Then put all the input and output data in worksheet tab.

4
 Go into design tab (parameter) put pressure drop of shell and tube side.

 Then put composition of component in respective streams.

5
 Go into the performance tab and note down the heat duty, Ft factor LMTD, and in
worksheet tab note down the outlet temperature of hot stream.

Results:
Outlet temperature of hot stream (oC) 107.7

Heat duty (kJ/h) 6.059e+4

Ft factor 0.988

LMTD (oC) 95.698

You might also like