HX426S15IB2/16 16GB 2G x 64-Bit DDR4-2666 CL15 260-Pin SODIMM
SPECIFICATIONS CL(IDD) 15 cycles Row Cycle Time (tRCmin) 45ns (min.) Refresh to Active/Refresh 350ns (min.) Command Time (tRFCmin) Row Active Time (tRASmin) 26.25ns (min.) Maximum Operating Power TBD W* UL Rating 94 V - 0 Operating Temperature 0°C to 85°C Storage Temperature -55°C to +100°C *Power will vary depending on the SDRAM used.
DESCRIPTION FEATURES HyperX HX426S15IB2/16 is a 2G x 64-bit (16GB) DDR4-2666 • Power Supply: VDD = 1.2V Typical CL15 SDRAM (Synchronous DRAM) 2Rx8, memory module, • VDDQ = 1.2V Typical based on sixteen 1G x 8-bit DDR4 FBGA components. Each module supports Intel® Extreme Memory Profiles (Intel® XMP) • VPP - 2.5V Typical 2.0. This module has been tested to run at DDR4-2666 at a low • VDDSPD = 2.25V to 3.6V latency timing of 15-17-17 at 1.2V. Additional timing parameters • On-Die termination (ODT) are shown in the PnP Timing Parameters section below. The • 16 internal banks; 4 groups of 4 banks each JEDEC standard electrical and mechanical specifications are as follows: • Bi-Directional Differential Data Strobe
• 8 bit pre-fetch Note: The PnP feature offers a range of speed and timing options to support • Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop) the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS. • Height 1.18” (30.00mm)
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
FOR MORE INFORMATION, GO TO HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston. Document No. 4808037-001.A00 Page 2
