Scribd
Upload
25 views2 pages

Installation

The document provides instructions for installing a cooling water pump on a Toyota 1GD-FTV engine. It describes removing the old pump and gasket, installing the new pump and gasket with specific bolts, connecting hoses and pipes to the pump with clamps and bolts, and attaching a wire harness.

Uploaded by

Edson CR
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
25 views2 pages

Installation

The document provides instructions for installing a cooling water pump on a Toyota 1GD-FTV engine. It describes removing the old pump and gasket, installing the new pump and gasket with specific bolts, connecting hoses and pipes to the pump with clamps and bolts, and attaching a wire harness.

Uploaded by

Edson CR
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Print-Toyota Service Information 11/3/17, 6(34 pm

Print Exit

1GD-FTV COOLING WATER PUMP INSTALLATION

PROCEDURE

1.INSTALL ENGINE WATER PUMP ASSEMBLY 16100

a.

Bolt A

Bolt B

Temporarily install a new gasket and the engine water pump assembly with the 8 bolts.
Bolt Length:
Item Length
Bolt A 45 mm (1.77 in.)
Bolt B 65 mm (2.56 in.)

b. Tighten the 8 bolts in the order shown in the illustration.


Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)

2.CONNECT NO. 1 TURBO WATER HOSE 16284

a. Connect the No. 1 turbo water hose to the engine water pump assembly and slide the hose clamp to secure
the hose.

3.CONNECT NO. 1 WATER BY-PASS PIPE 16268

https://toyotamanuals.com.au/docs/hilux-service-repair-manual-…manual/repair/contents/RM100000000MV8D.html?PUB_TYPE=RM&MODE=1 Page 1 of 2
Print-Toyota Service Information 11/3/17, 6(34 pm

a.

*a Claw

Install a new gasket to the No. 1 water by-pass pipe as shown in the illustration.
HINT:
Make sure that the claws of the gasket are facing the No. 1 water by-pass pipe.

b. Connect the No. 1 water by-pass pipe to the engine water pump assembly with the 3 bolts.
Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

c. Attach the wire harness clamp and connect the 2 connectors to the turbocharger sub-assembly.

4.INSTALL WATER INLET 16321

Click hereEngine / Hybrid System>1GD-FTV COOLING>THERMOSTAT>INSTALLATION

© 2012 TOYOTA MOTOR CORPORATION. All Rights Reserved.

https://toyotamanuals.com.au/docs/hilux-service-repair-manual-…anual/repair/contents/RM100000000MV8D.html?PUB_TYPE=RM&MODE=1 Page 2 of 2

You might also like