Scribd Logo
Upload

Welcome to Scribd!

  • 17 views

    Ap 4 PDF

    Uploaded by

    Roberto Diaz

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Ap 4 PDF

    Uploaded by

    Roberto Diaz
    17 views2 pages

    Original Title

    AP-4 PDF

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    17 views2 pages

    Ap 4 PDF

    Uploaded by

    Roberto Diaz

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 2

    220480B.

    qxd 6/5/02 9:07 AM Page 1

    AccessPro Controller
    Model AP-4
    • Ideal for gated communities, parking facilities,
    and industrial sites.
    • Easy to set-up and use — up to 480 remotes
    can be programmed with a few keystrokes.
    • Easy to add, suspend, and delete transmitters
    through programming mode — no transmitter
    dip switches to set.
    • Supports 480 block coded transmitters or
    238 individual transmitters/wireless keypad
    entry codes.
    • Supports one fully supervised safety edge
    transmitter.

    For sites that have a single entrance or gate, the AP-4 is


    the ideal wireless-based access control system. It can be
    used to remotely activate devices such as gate operators,
    door strikes, or door operators. Based on and priced the
    same as the proven AP-3 access controller, the AP-4 is
    small enough to be mounted within the gate operator. It
    represents a tremendous value over older dip switch style
    products that are priced nearly the same.
    The AP-4 has a built-in radio receiver. It has a 250 foot
    range that can be extended even farther with an optional
    EXA-2000 antenna.The AP-4 is compatible with all
    MegaCode format transmitters, which come factory
    programmed with one of over 1,000,000 possible codes,
    all but eliminating any chance of duplication. It accepts
    either 480 block coded transmitters or 238 individual
    transmitters or wireless keypad entry codes. For the latter,
    the AP-4 can be used with Linear’s wireless MDKP
    keypad, which accepts user codes of two to six digits and
    transmits them to the AP-4 controller.
    Two relay outputs are provided: one for gate or door
    access; the other for obstacle control using the MGT,
    the industry’s only supervised safety edge transmitter.
    The AP-4 looks for an hourly status transmission from
    the MGT to report on transmitter functionality, battery
    condition, and case integrity. If any of those conditions
    require attention, the AP-4 will alert the user by beeping
    once every five seconds.The user must then activate the
    transmitter twice in order for the AP-4 to grant access.
    Installation and set-up are simple.The AP-4 operates
    on 12-24 volts, ac or dc. It can be powered directly from
    the radio power output of most gate operators. Learning,
    suspending, or deleting transmitters is as simple as
    pressing a few keys on the AP-4’s built-in keypad. Program
    data is stored in non-volatile EEPROM; data retention is in
    excess of ten years, even in the event of a power failure.
    220480B.qxd 6/5/02 9:07 AM Page 2

    Typical Gate Application

    General Specifications OPERATING TEMPERATURE


    -22° to +170°F (-30° to +77°C)

    DIMENSIONS
    OUTPUTS 3.625 in W x 5.25 in H x 1.5 in D (92 x 133 x 38 mm)
    Relay: two form “C” relays, rated at 1 amp @ 24 volts ac
    or dc; one for control and one for obstacle STANDARD EQUIPMENT
    Display: three seven-segment displays to provide AP-4 controller; supports 480 MegaCode block coded
    system activity and program data; LEDs used in conjunc- transmitters or 238 individual transmitters/wireless key-
    tion with displays to provide transmitter and radio activity pad entry codes, plus one MGT safety edge transmitter;
    9-1/2 inch whip antenna; 3 feet of coaxial cable; barrel
    INPUTS connector
    RF: integral 318 MHz super regenerative receiver @ -94
    dBm sensitivity (nominal); receives MegaCode transmitters ACCESSORIES
    Open Request: terminal input and button activation
    triggers the control relay Antennas:
    Keypad: integral 16-key membrane style keypad with a. EXA-1000: remote, omnidirectional; includes mounting
    tactile feedback hardware and five feet of cable
    b.EXA-2000: remote, directional-type; includes mounting
    hardware and ten feet of cable
    POWER
    12 to 24 volts ac or dc, 250 mA maximum Wireless Keypad: Linear’s MDKP
    Transmitters: any of Linear’s many MegaCode models

    2055 Corte Del Nogal, Carlsbad, CA 92009


    (760) 438-7000 (800) 421-1587 Fax (800) 468-1340
    www.linearcorp.com
    Copyright 2002, Linear Corporation 02-89 P/N 220480 B Printed in HK

    You might also like