Digital Component ESR Meter Multi-function Tester
Model: ESR02 pro
User Manual
Product Details:
Function Testing:
Usage Instructions:
a. Power ON: Press “POWER/TEST” button before using.
b. Test: Press “POWER/TEST” button to start a test. Regardless of the pin sequence, this meter will
recognize the pin’s function and layout on the screen.
c. Power OFF: Automatically power down if no button operation in 20 seconds.
d. Test Socket: With 3 test sockets, SMD socket, Plug-in devices socket and Probe socket. The port 1,
2, 3 of each socket are the same, they are connected internal.
e. SMD Device Test: Test via SMD socket or probe. While using SMD socket, put some pressure on
device for better connection.
f. Electrolytic Capacitor Discharge Support max 2000uF/50V capacitor discharge with the internal
1K/1W resistor, and discharge of 2 seconds at least.
Use external discharger while the capacity is higher.
Discharge is standalone function, no need to power on or press button.
g. Selection Menu: A long button press (>0.5s) will enter the selection menu for additional functions.
Short button press to switch different functions and long button press (>0.5s) to enter Submenu.
Switch off: Long button press to power Off immediately.
Transistor: exit Selection Menu, return to transistor test.
Frequency: reserved.
f-Generator: with the button press can select different frequencies output from T2 (Test Port
2), and T1, T3 will be the reference ground. Frequencies selectable from 1 Hz to 2 MHz, amplitude
is 5V.
10-bit PWM: Generates a 7.8KHz frequency with selectable pulse width at the pin T2. With a
short button press (<0.5s) the pulse width is increased by 1%, with a longer button press (>0.5s,
<1.3s) the pulse width is increased by 10%.
C+EST@TP1:3: It’s a stand-alone capacity measurement with ESR measurement at the test pins
T1 and T3.
Rotary Encoder: Reserved.
Self-test: Full self-test with calibration.
Contrast: Contrast value for a graphic display, selectable from 33to 55.
Note: In selection mode, the Tester will auto power off after 8 minutes without any button press.
Attention:
Always be sure to discharge capacitors before connection them to the tester.
Power down the equipment if test components mounted in a circuit.
If using DC supply, please choose DC 9V-12V adapter (including 9V and 12V).
When the battery power is under 6V, please replace a new one.
Calibration:
Short T1, T2, T3 to one, then press button.
When LCD shows “Selftest mode.. ?”, press button within 2 seconds to enter calibration mode,
otherwise will come into transistor test mode.
Tester automatic calibration until LCD shows “isolate Probes!”, then separate T1, T2 and T3.
Wait a few seconds until LCD shows “Test End”.
