Scribd
Upload
151 views2 pages

Lab 02 - Pulse Code Modulation (PCM) - Lab Report

The document describes an experiment on pulse code modulation (PCM) conducted by students. It involves simulating PCM in Simulink, sampling an analog voltage using an STM32 microcontroller and ADC, observing the frame sync and clock signals on an oscilloscope, and plotting and analyzing the PCM output signal.

Uploaded by

iso640574
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
151 views2 pages

Lab 02 - Pulse Code Modulation (PCM) - Lab Report

The document describes an experiment on pulse code modulation (PCM) conducted by students. It involves simulating PCM in Simulink, sampling an analog voltage using an STM32 microcontroller and ADC, observing the frame sync and clock signals on an oscilloscope, and plotting and analyzing the PCM output signal.

Uploaded by

iso640574
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Kocaeli University, Electronics and Telecommunications Engineering Department

Digital Communications Laboratory


Experiment 2: Pulse Code Modulation (PCM) - Lab Report (04.03.2024)
Name-Surname-Number:
Name-Surname-Number:
Name-Surname-Number:

SIMULINK PART - The table below is for verification only and filled by the lab instructor.
Understanding sample rate and quantization levels (15 pts)
Understanding quantization errors (10 pts)
Understanding PCM representation of each quantization level (15 pts)

STM32 PART - Section 1: Sampling an Analog Voltage


Step 1: Build a voltage divider using a potentiometer (place it on a breadboard) and connect the
variable voltage pin of the potentiometer to ADC input pin (A5 on Nucleo-64 or PC0 on Discovery).
Step 2: Run your STM32 C code in debug mode, inspect the value of adcValue variable in
Watch1 and fill in the table below. (15 pts)
Analog n = 8 bit
Voltage
3.3V

0V
Section 2: PCM Bits
Step 3: Connect NI Elvis II Scope CH0 to Frame Sync Signal (D8 on Nucleo-64 or PA9 on
Discovery).
Step 4: Connect NI Elvis II Scope CH1 to Clock Signal (D6 on Nucleo-64 or PB10 on Discovery).
Step 5: Adjust the Scope divisions (1V/Div, 125µS/Div). Set Scope CH0 vertical position at -3V. Set
your Scope “Trigger Type” to “Edge”, “Level” to “1V” and Trigger “Source” to “Scope CH0”. (5 pts)
Step 6: How many Clock Signal Cycles (periods) between two Frame Sync Signal Pulses? Fill the
Table below. (5 pts)
Clock Cycle Counts
Step 7: Plot your Scope screen on the left graph. (15 pts)
Step 8: Disconnect Scope CH1 from Clock Signal and connect it to PCM output (D7 on Nucleo-64
or PA8 on Discovery).
Step 9: Plot your Scope screen on the right graph. (15 pts)
Section 3: Mastering PCM C Code
Step 10: Answer the question written on whiteboard. (20 pts)

You might also like