Structuro W425
Structuro W425
Structuro W425
Uses
Structuro W425 is a high performance Mid-range Structuro W425 combines the properties of water reduction
hyper-plasticizer intended for applications where higher and workability retention. It allows the production of high
water reduction and workability retention with increased performance concrete and/or concrete with high workability.
ultimate compressive strength is required, and it has been
Structuro W425 is a particularly strong hyperplasticiser
developed for use in:
allowing production of consistent concrete properties around
Piling concrete, raft foundations, mass concrete and the required dosage.
other structural concrete like piers, pile caps and etc.
Self compacting concrete Technical support
Pumped concrete Fosroc provides a technical advisory service for on-site
Concrete requiring long workability retention assistance and advice on admixture selection, evaluation
High performance & high grade concrete(M30 to M80) trials and dispensing equipment. Technical data and guid-
ance can be provided for admixtures and other products for
Advantages use with fresh and hardened concrete.
Reduced shrinkage and creep Dosage guideline range is between 0.2 to 2.0% by weight of
cement or cementitious materials including PFA, GGBFS &
Increased durability microsilica.
Structuro W425 conforms with BS 5075, BS:EN 934-2 and Dosages outside the above dosage guidelines can be used
with ASTM C494 as Type F and G depending on dosage to meet particular concrete mix requirements. Please
used. contact Fosroc for advice in such cases.
Effects of overdosing
Description
Overdosage may cause delay in the setting time.
Structuro W425 is differentiated from conventional super-
plasticisers in that it is based on a unique carboxylic ether
polymer with long lateral chains. This greatly improves
cement dispersion. At the start of the mixing process an
electrocstatic dispersion occurs but the presence of the
lateral chains, linked to the polymer backbone, generate a
steric hindrance which stabilises the cement particle’s
capacity to separate and disperse. This mechanism consid-
Structuro W425
Structuro W425 is suitable for use with all types of Portland Precautions
cements and cement replacement materials such as PFA,
Health and safety
GGBFS, SRC and microsilica.
Structuro W425 does not fall into the hazard classifications
Mixing
of current regulations. However, it should not be swallowed
When used at the mixing plant, Structuro W425 should be or allowed to come into contact with skin and eyes.
added in the mixing water. Suitable protective gloves and goggles should be worn.
In some instances, e.g. addition to ready mix concrete on Splashes on the skin should be removed with water. In case
site, Structuro W425 can be added directly in the truck mixer of contact with eyes rinse immediately with plenty of water
and mixed at maximum speed for an extra 5 minutes. and seek medical advice. If swallowed seek medical atten-
For high flow Self compacting concrete, Auramix V200 can tion immediately - do not induce vomiting.
be used at a dosage between 0.5 to 1.5 Litres per cubic For further information refer latest version of Material Safety
meter. Data Sheet(MSDS) available for this product.
Dispensing Fire
The correct quantity of Structuro W425 should be measured Structuro W425 is water based and non-flammable.
by means of a recommended dispenser. The admixture
should then be added to the concrete with the mixing water Cleaning and disposal
to obtain the best results. Contact Fosroc for advice regard- Spillages of Structuro W425 should be absorbed onto sand,
ing suitable equipment and its installation. earth or vermiculite and transferred to suitable containers.
Remnants should be hosed down with large quantities of
Estimating water.
Important note
Fosroc products are guaranteed against defective materials and manufacture and are sold subject to its standard Conditions for the Supply of
Goods and Service. All Fosroc datasheets are updated on a regular basis. It is the user’s responsibility to obtain the latest version.
Head Office
telephone: (+9714) 2039699 fax: (+9714) 2859649 email: [email protected]
Al Gurg Fosroc LLC
Regional offices
Post Box 657, Dubai Abu Dhabi, Al Gurg Fosroc telephone: 673 1779 fax: 673 1449 email: [email protected]
Bahrain, YBA Kanoo telephone: 17738200 fax: 17732828 email: [email protected]
United Arab Emirates Kuwait, Boodai telephone: 4817618 fax: 4832124 email: [email protected]
Oman, Al Amana telephone: 24815080 fax: 24817554 email: [email protected]
www.fosroc.com
UAE/0657/16/D