Fosroc® Structuro® W422 constructive solutions

Superplasticizer - Low-Range superplasticizer based on

polycarboxylate technology

Uses Technical support

 To provide excellent slump retention properties in tropical Fosroc provides a technical advisory service for on-site assis-
conditions even at low water cement ratio. tance and advice on admixture selection, evaluation trials and
dispensing equipment. Technical data and guidance can be
 Particularly suitable for high strength concrete.
provided for admixtures and other products for use with fresh
 To significantly improve the workability of site mixed con- and hardened concrete.
crete without increasing water demand.
Dosage Guideline
 To provide improved durability by increasing ultimate
strengths and reducing concrete permeability. The optimum dosage of Structuro W422 to meet specific re-
quirements should always be determined by trial mixes using
Advantages the materials and conditions that will be experienced in use.
Guideline dosage range is between 0.2 to 2.2 % by weight of
 Makes possible reductions in water:cement ratio which
cement or cementitious materials including PFA, GGBFS &
allow the production of high strength concrete without
microsilica.
excessive cement contents.
Use at other dosages
 Use in production of flowing concrete permits easier con-
struction with quicker placing and compaction and reduced Dosages outside the above dosage guidelines can be used to
labour costs without increasing water content. meet particular concrete mix requirements. Please contact
 Improved cohesion and particle dispersion minimises Fosroc for advice in such cases.
segregation and bleeding and improves pumpability.
Effects of overdosing
 Chloride free, safe for use in prestressed and reinforced
An overdose of Structuro W422 will result in an increase in
concrete.
retardation and air content as compared to that normally ob-
tained. Provided that adequate curing is maintained, the ulti-
Standards compliance
mate strength of the concrete will not be impaired by increased
Structuro W422 conforms with BS 5075, BS:EN 934-2 and with retardation and will generally be increased. The effects of
ASTM C494 as Type F and G depending on the dosage used. overdosing will be further increased if sulphate resisting cement
or cement replacement materials are used.
Description
Typical Properties
Structuro W422 is differentiated from conventional superplas-
ticisers in that it is based on a unique carboxylic ether polymer
Appearance : Light yellow coloured liquid
with long lateral chains. This greatly improves cement disper-
Specific gravity : 1.03 ±0.02 @ 25°C
sion. At the start of the mixing process an electrocstatic dis-
Chloride content : Nil to BS 5075 / BS:EN934
persion occurs but the presence of the lateral chains, linked
to the polymer backbone, generate a steric hindrance which
stabilises the cement particle’s capacity to separate and dis-
perse. This mechanism considerably reduces the water de-
mand in flowable concrete.

Structuro W422 combines the properties of water reduction

and workability retention. It allows the production of high per-
formance concrete and/or concrete with high workability.

Structuro W422 is a particularly strong superplasticiser allow-

ing production of consistent concrete properties around the
required dosage.
Structuro W422
Fosroc® Structuro® W422

Instructions for use Packaging

Mix design Structuro W422

Bulk and 1000 Liter Plastic Totes
Where the main requirement is to improve strengths, initial
trials should be made with normal concrete mix designs. The For larger users, storage tanks can be supplied.
addition of the admixture will allow the removal of water from
the mix whilst maintaining workability. After initial trials, minor
modifications to the overall mix design may be made to optimise Storage
performance.
Structuro W422 has a minimum shelf life of 6 months provided
the temperature is kept within the range of 5°C to 50°C. Should
Where the main requirement is to provide high workability the temperature of the product fall outside this range then
concrete, the mix design should be one suitable for use as a contact Fosroc for advice.
pump mix. Advice on mix design for flowing concrete is avail-
able from Fosroc.
Precautions
Compatibility Health and safety
Structuro W422 is suitable for use with all types concrete Structuro W422 does not fall into the hazard classifications of
mixes produced with Portland Cements (OPC) and mixes with current regulations. However, it should not be swallowed or
cement replacement materials such as PFA, GGBFS, SRC allowed to come into contact with skin and eyes.
cements or microsilica.
Suitable protective gloves and goggles should be worn.
Structuro W422 should not be used in combination with any Splashes on the skin should be removed with water. In case
other admixture unless prior approval is obtained from your of contact with eyes rinse immediately with plenty of water and
local Fosroc office. seek medical advice. If swallowed seek medical attention im-
mediately - do not induce vomiting.
All admixtures should be added to the concrete separately
and must not be premixed together prior to addition. The For further information consult the Material Safety Data Sheet
use of a combination of admixtures in the same concrete available for this product.
mix may alter the setting time. The resultant properties of
concrete containing more than one admixture should be Fire
assessed by lab/or plant trial mixes to confirm the desired
Structuro W422 is water based and non-flammable.
properties of concrete before use.
Cleaning and disposal
Dispensing
Spillages of Structuro W422 should be absorbed onto sand,
The correct quantity of Structuro W422 as per the approved
earth or vermiculite and transferred to suitable containers.
mix designs based on lab/plant trials should be measured
Remnants should be hosed down with large quantities of water.
by means of a recommended dispenser or load cells.
Normally, the admixture should then be added to the The disposal of excess or waste material should be carried out
concrete with the mixing water to obtain the best results. in accordance with local legislation under the guidance of the
These admixtures are not recommended to be added in dry local waste regulatory authority.
aggregates or cement. It should always be added in wet mix
conditions.

Full blending of the admixture and the concrete should be

ensured by mixing at high speed.

® Denotes the trademark of Fosroc International Limited

Important note
Fosroc products are guaranteed against defective materials and manufacture and are sold subject to its standard Conditions for the Supply of
Goods and Service. All Fosroc datasheets are updated on a regular basis. It is the user’s responsibility to obtain the latest version.

Head Office
telephone: (+9714) 2039699 fax: (+9714) 2859649 email: [email protected]
Al Gurg Fosroc LLC
Regional offices
Post Box 657, Dubai Abu Dhabi, Al Gurg Fosroc telephone: 673 1779 fax: 673 1449 email: [email protected]
Bahrain, YBA Kanoo telephone: 17738200 fax: 17732828 email: [email protected]
United Arab Emirates Kuwait, Boodai telephone: 4817618 fax: 4832124 email: [email protected]
Oman, Al Amana telephone: 24815080 fax: 24817554 email: [email protected]
www.fosroc.com
UAE/0826/18/C