JDR810UV2/ JDR 840V2: ADSL2+ Router
JDR810UV2/ JDR 840V2: ADSL2+ Router
JDR 840V2
ADSL2+ Router
The ADSL Router compliance to supported ADSL standards : ANSI T1.413 Issue
2, ITU-T G.992.1 (G.dmt), ITU-T G.992.2 (G.lite), ITU-T G.992.3
(G.dmt.bis/ADSL2), and ITU-T G.992.5 (ADSL2plus) specification. Both Annex
A (ADSL over POTS) and Annex B (ADSL over ISDN) are supported.
▓ ADSL COMPLIANCE
-Full-rate ANSI T1.413 Issue 2
-ITU G.992.1 (G.dmt) Annex A and B
-Splitterless ITU G.992.2 (G.lite) specification
-ITU G.994.1 (G.hs)
-ITU G.992.3 (G.dmt.bis / ADSL2)
-ITU G.992.5 (ADSL2plus)
-Supports splitterless ADSL implementation
-Supports Dying Gasp
-Supports RMON (Remove Monitoring)
▓ ATM SUBSYSTEM
-PPP over ATM (RFC 2364)
-Bridged IP over ATM (RFC 1483)
-PPP over Ethernet (RFC 2516)
-Multiprotocol Encapsulation over AAL5 (RFC 2684)
-Supports up to 8 Virtual Channel Connections (VCCs)
-Supports UBR, CBR, and VBR service classes
-ATM Forum UNI 3.1/4.0 PVC
-Support OAM F4/F5 look-back, AIS and RDI OAM cells
▓ FEATURES
-IP Alias
-User Datagram Protocol (UDP)
-Transmission Control Protocol (TCP)
-Internet Control Message Protocol (ICMP)
-Internet Group Management Protocol (IGMP)
-PPP over PAP (RFC1334)
-PPP over CHAP (RFC1994)
-MIB II support (RFC1213)
-Transparent bridging as specified in IEEE 802.1D
- NAT (Network Address Translation)
-Dynamic Host Configuration Protocol (DHCP)
-Dynamic DNS support
-Routing Information Protocol (RIP) v1 and v2
▓ ETHERNET INTERFACE
-IEEE 802.3
-10/100 Mbps
-Ethernet interface supporting up to 64 LAN hosts
▓ VISUAL INDICATORS
-PWR on when power on
-DSL LINK on when ADSL is connected, flashing when attempting connection
-DSL ACT on when transmitting/receiving data on the WAN
-LAN LINK on when Physical Ethernet link is up
Ordering information
MODEL DESCRIPTION
JDR840V2 ADSL 2+ Router with 4-Port Switch
JDR810UV2 ADSL 2+ Router with 1-Port Switch and 1 USB Port