Wearflex 1000 v2

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

®

TECHNICAL DATA SHEET – DENSIT® WEARFLEX 1000 Revised: v2 04/2021

CHEMICALLY BONDED BAUXITE-CERAMIC

DESCRIPTION SPECIFICATION
Densit® WearFlex 1000 wear resistant linings provide • Install mesh
excellent protection against high erosive wear at tempera- • Mix dry compound for 1 minute
tures up to 400°C (750°F). • Add water and mix for 8 minutes
• Trowel mix onto mesh
• Apply Densit ® Curing Compound
CONSUMPTION AT 25 MM
• For more details refer to the “Densit ® WearFlex Manual”
Densit® WearFlex 1000 65 kg/m 2

Densit® Anchoring mesh 1 m 2/m 2 Densit ® WearFlex 1000 is a trowellable one-component


ready-mix delivered in 25 kg bags.
Densit® Curing Compound 0.25 l/m 2
The bags must be stored on a dry stock to maintain the good
properties of the compound. The guaranteed shelf life is 14
months from production date A paddle mixer must be used
CONSUMPTION AT 40 MM
for mixing the compound. A significant change in consistency
Densit® WearFlex 1000 104 kg/m2 of the material (from dry to plastic) must be observed within
3 minutes from addition of water. Avoid Densit® compound
Densit® Anchoring mesh 1 m 2/m 2 to make contact with aluminium or galvanised steel. Densit®
WearFlex 1000 should be installed on a standard expanded
Densit® Curing Compound 0.25 l/m2 metal mesh welded on the steel casing.
® TECHNICAL DATA SHEET – DENSIT® WEARFLEX 1000

TECHNICAL DATA

PROPERTIES STANDARD DENSIT ® WEARFLEX 1000

Density kg/m3 - (lb/ft3) EN 1015-6 2650 (165)

Compressive strength - MPa EN 12190 200

Flexural strength - MPa EN 196-1 25

Dynamic E-modul - MPa EN 12504-4 70-80 103

Casting shrinkage - vol.% 0.2

Thermal conductivity - w/m°C 1.5

Coeff. of thermal expansion - 1/°C (1/°F) EN 1770 10x10-6 (5.6x10-6)

Heat capacity - KJ/kg°C 0.9-1.0

Max. service temperature - °C (°F) 400 (750)

Abrasion resistance - cm3/50cm2 DIN 52108 3-4

Erosive resistance - min/cm3 100

% CaO 20
% SiO2 30
Chemical composition - % Al O2 3 + TiO 2 EN 196-10 48
% Fe2 O3 <0.7
% Cr6+ <0.0002
Bag size - kg 25

Pallet size - kg 1250

The figures given are typical values.


Please contact ITW Performance Polymers or the nearest distributor for further information.

ITW PERFORMANCE POLYMERS


Rørdalsvej 44 | 9220 Aalborg | Denmark | T: +45 9816 7011 | [email protected] | www.itwperformancepolymers.com

You might also like