Scribd
Upload
16 views1 page

Common Instructions ABB and Fanuc

Uploaded by

VENANCIO DAVID SALAZAR QUIJADA
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
16 views1 page

Common Instructions ABB and Fanuc

Uploaded by

VENANCIO DAVID SALAZAR QUIJADA
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ROBOT Programming

ABB and Fanuc’s Commonly used Instructions / Statements

ABB FANUC
Motion Instructions
MOVEJ p10, v100, z15, tool0; 1: J P[2] 50% CNT25;
2: -- J speed data expressed in %;
MOVEL p20, v150, fine, tool0; 1: L P[5] 250 mm/sec FINE;
2: -- other speed option for L, cm/min, inch/min, ….;
MOVEC midpoint, targetpotint, v250, fine, tool0; 3: C P[5: midpoint] : P[11: targetpoint] 200
mm/sec FINE;
I/O Operations
SET DO3; 1: DO[3] = ON;
2: -- activate digital output number 3;
RESET DO3; ! RESET means 3: DO[3] = OFF;
4: -- deactivate the digital output number 3
deactivate
WAITDI DI7, 1; ! wait until digital input DI7 1: WAIT DI[7] = ON, TIMEOUT, LBL[33];
becomes high 2: -- wait until digital input 7 gets activated (high);
3: -- optional timeout clause causes the program pointer
to move to LBL[…] specified label;
Miscellaneous
! conditional branching ! conditional branching
IF <cond> THEN IF <condition expression>, <action; CALL or JMP>
<instructions / actions>
ELSE -- for newer controllers
<instructions / actions> IF <cond> THEN
ENDIF <instructions / actions>
ELSE
<instructions / actions>
ENDIF
! FOR loop ! FOR loop
FOR counter_var FROM initial_value TO final_value FOR R[..] = initial_value TO final_value
STEP step_value DO <instructions / actions >
<instructions / actions >;
ENDFOR ENDFOR
! WAIT instructions ! WAIT instructions
WAITUNTIL <condition>; WAIT <condition> ; or
WAIT <condition>, TIMEOUT, LBL[...];
WAITTIME <number of seconds> ;
WAITDI <digitl input>, <intended value>; WAIT <number of seconds>(sec);

OFFSET instruction
- for Fanuc, OFFSET instruction should be used with a position
OFFS function
register (PR), PR holds the actual Offset value with reference of a
this function is for moving the robot to a point without
already taught position.
teaching that point. Examples:-
Example:-
MOVEL pt1, v1000, fine, tool0;
10: PR[25, 1]= 25;
MOVEL Offs(pt1, 25, 0, 0), v100, fine, tool0;
11: L P[1] 250 mm/sec FINE;
! the above program lines will make the robot move to 'pt1'
12: L P[1] 250 mm/sec FINE OFFSET, PR[25]
first then 25 mm in 'x' direction from that point.
-- same action and result as the ABB program listed on the left
column;

You might also like