Scribd
Upload
80 views2 pages

ET403T - Analog Circuit Design - 4 Sem - ET

The document describes a course on Analog Circuit and Design. It outlines the course objectives, outcomes, topics to be covered over 5 units including op-amp fundamentals, linear and non-linear applications, oscillators, power supplies and active filters. It also lists the textbooks and references for the course.

Uploaded by

regaltos91
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
80 views2 pages

ET403T - Analog Circuit Design - 4 Sem - ET

The document describes a course on Analog Circuit and Design. It outlines the course objectives, outcomes, topics to be covered over 5 units including op-amp fundamentals, linear and non-linear applications, oscillators, power supplies and active filters. It also lists the textbooks and references for the course.

Uploaded by

regaltos91
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

ST.

VINCENT PALLOTTI COLLEGE OF ENGINEERING & TECHNOLOGY, NAGPUR


(An autonomous institution affiliated to Rashtrasant Tukadoji Maharaj Nagpur University)
B. Tech. Scheme of Examination & Syllabus 2023-24
ELECTRONICS AND TELECOMMUNICATION ENGINEERING

FOURTH SEMESTER

Course Code Course Name Th Tu Pr Credits Evaluation


CA ESE Total
ET403T Analog Circuit & Design 3 1 0 4
30 70 100

Course Objectives Course Outcomes


1. To study the basic characteristic, After completion of the course students are able to,
construction, open loop & close loop
operations of Op-Amp. 1. To explain the basic differential amplifier using transistor, ideal op
amp and basic feedback configurations.
2. To study linear and non linear applications 2. To demonstrate and evaluate practical integrator, differentiator
of Op-Amp. circuits, instrumentation amplifier, logarithmic & anti logarithmic
3. To study the design of Electronic Circuits amplifier circuits.
for Oscillator, Multivibrator and Active 3. To explain & evaluate practical Schmitt trigger, comparator,
Filters Clipper, clamper, precision rectifier circuits, Design of phase
locked loop, Astable , nonstable, circuits using an opamp IC and
timer.
4. To explain & design Hartley,Colpitts, Crystal oscillators using
transistors ,Quadrature,RC phase shift & Wein bridge oscillators
using op-amp along with diode function generator circuit and
opamp.
5. To Analyze design active Butterworth filters up to 6th order

UNIT- I: OP-Amp Fundamentals [10 Hrs]

Block diagram of OP-Amp (Basic Building Blocks), Basic differential Amplifier using transistor and its operation, current
mirror circuit, OP-Amp parameters, characteristic and Definition, Ideal OP-Amp, Equivalent circuit, Voltage Transfer curve,
concepts of virtual short and ground.
Inverting and Non-inverting configurations and design.
Unit –II:- OP-Amp Linear Applications [10 Hrs]

Voltage follower, Summing amplifier, scaling and averaging amplifier, Bridge Amplifiers using opamp, Instrumentation
amplifier and applications, Integrator and differentiators (Practical considerations and design), Peak detector, Log and antilog
amplifiers using OP-Amp, V to I and I to V converter circuit.

Unit –III:- OP-Amp Non-Linear Applications [10 Hrs]

Comparators, Schmitt trigger, Comparator IC such as LM 339, Clipper and Clamper, PLL Multivibrators:, Astable &
Monostable multivibrator circuits using IC 555, Sample/Hold circuits,D/A (R/R) & A/D conversion circuits (Successive
Approximation Method), design of ADC using 0804 ICs.

UNIT- IV: Design power supply and Oscillators [11 Hrs]

Design of linear and switching power supplies:- Design of opmap based series voltage regulator, Design of Buck and boost
switched mode power supply, Design of high efficiency SMPS using soft switching technique.Design of sinusoidal oscillators
OPAMP based Wein Bridge ,Phase Shift oscillators, Transistorized Hartley, Colpitts oscillator, and Crystal oscillators,
Evaluation of figure of merit for all above oscillator circuits. Design of function generator using an opamp.
1
October 2022 Applicable for
2022-23
Chairman - BoS Dean – Academics Date of Release Version
ST. VINCENT PALLOTTI COLLEGE OF ENGINEERING & TECHNOLOGY, NAGPUR
(An autonomous institution affiliated to Rashtrasant Tukadoji Maharaj Nagpur University)
B. Tech. Scheme of Examination & Syllabus 2023-24
ELECTRONICS AND TELECOMMUNICATION ENGINEERING
Unit -V: Design of Active Filters [7 Hrs]

Advantages of active filters, Design of Butterworth Active Filter(upto 6 th order) , Design of Active filter of LPF, HPF, BPF and
switched capacitor filter. Design of relay driver circuit using transistor and op-amp, Design of IGMF filters

Text Books
S.N Title Authors Edition Publisher
1 Operational Amplifier and Applications R. Gayakwad. 3 PHI
2 Electronic Devices and Circuits David Bell 5 Oxford Higher
Education
3 Designing with Op-Amps Franco McGraw Hill

Reference Books
S.N Title Authors Edition Publisher
1 Linear Integrated Circuits Mannal I, II, National
and III Semiconductor
2 Linear Applications Handbook National
Semiconductors
3 Operational Amplifier Dailey McGraw Hill

4 Operational Amplifier Design and Tobey, Graemme, 1 McGraw Hill.


Applications Huelsman

1
October 2022 Applicable for
2022-23
Chairman - BoS Dean – Academics Date of Release Version

You might also like