Scribd
Upload
13 views18 pages

21bee0334 Da3

The document describes several experiments involving simulations and hardware setups of power electronics circuits including single phase PWM inverters, cycloconverters, three phase inverter fed induction motors, and speed control of induction motors. The experiments were conducted and results were recorded and verified.

Uploaded by

lakshit.choudhary2021
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
13 views18 pages

21bee0334 Da3

The document describes several experiments involving simulations and hardware setups of power electronics circuits including single phase PWM inverters, cycloconverters, three phase inverter fed induction motors, and speed control of induction motors. The experiments were conducted and results were recorded and verified.

Uploaded by

lakshit.choudhary2021
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 18

Name: Manav Kumar Agarwal Registration No.

: 21BEE0334
Experiment Number: 7
Course: Power Electronics and Drives Lab

Aim
To simulate a single phase unipolar and bipolar PWM inverter on MATLAB/Simulink.

Apparatus Requirements

MATLAB

Circuit-
3

3
4

Result
For the given problem statements, answers were calculated manually and also
the code for the same was written and executed on MATLAB. The answers
were matched and they were equal (negligible deviations). Therefore, Verified.

4
5

Name: Manav Kumar Agarwal Registration No.: 21BEE0334


Experiment Number: 8
Course: Power Electronics and Drives Lab

Aim
To simulate a cycloconverter on MATLAB/Simulink and verify the simulation and
expected.results. Analyse the waveforms for the Step down cycloconverter.

Apparatus Requirements

MATLAB

Simulink Model-

5
6

6
9

9
9

Result

After the hardware simulation was completed, the results were recorded in the
tabular observation column. The hardware setup is verified to be correct.by
comparing the theoretical and hardware values.

9
9

Name: Manav Kumar Agarwal Registration No.: 21BEE0334


Experiment Number: 09
Course: Power Electronics and Drives Lab

AIM: Three Phase PWM inverter fed induction motor drives in Hardware

Apparatus Requirements:
1. Three phase Supply voltage (RYB)
2. Semikron skyper board
3. TLP250

Circuit Diagram

9
1

1
1

1
1

Name: Manav Kumar Agarwal Registration No.: 21BEE0334


Experiment Number: 10
Course: Power Electronics and Drives Lab

Aim
To perform a hardware setup of a 3phase induction motor and perform speed control teston
the motor.

Apparatus Requirements

1. 6 IGBT Switches 25N120KBA


2. STM32 micro controller
3. Digital Oscilloscope
4. Programmable RPS

Circuit Diagram

1
1

1
1

1
1

Circuit Photo-

1
1

1
1

1
1

Result-
After the hardware simulation was completed, the results were recorded in the
tabular observation column. The hardware setup is verified to be correct.by
comparing the theoretical and hardware values.

You might also like